Pyle PKBRTP299 Instruction Manual - Page 1

PKBRTP99 - PKBRTP299 Homebrew Double Wall Mini Keg Beer Dispenser UNIT OPERATION INSTRUCTION 1 3 2 4 5 9 11 10 12 6 7 8 1. Mini keg Growler 2. Cap Spear Body 3. Gas In Connection Tube 4. Pressure Relieving Valve 30PSI. 5. Cross-bar 6. Regulator Base 7. 30 PSI Pressure Gauge 8. CO2 Regulator Knob 9. CO2 Regulator Aluminium Body 10. Black Plastic Tap Handle. 11. Chrome Plated Faucet Body 12. Beer Tube www.NutriChefKitchen.com PART ONE: SPEAR ACCEMBLY 1. Please clean mini keg, cap, spear body, faucet and beer hose with warm water and mild soap before use. 2. Fill your mini keg at your favourite craft brewery, or with your own homebrew. 3. Cut beer hose according to keg height and insert into spear, make sure hose can touch bottom of keg without overlong or over short. Remark: If hose is too short, beer would not be tapped completely. But if hose is too long, it may crimp inside the keg, also cause incomplete tapping. 4. Fit tube on to spear, and screw spear into mini keg. NOTE: DON'T stop turning if you hear a slight gas leak swish, nish turning it in all the way it seal properly. PART TWO: TAPPING 1. Connect the regulator with capsule to the spear. 2. Install faucet into spear body, make sure the connection is proper and tight. 5. Check whether the regulator knob is in OFF position. If not, please follow arrow mark instruction to turn the regulator knob counter clockwise to the OFF position. Remark: Improper combination would cause leakage of beer. 3. Pull on pressure relieving ring for a couple of seconds. If the keg was shaken in transit or warmed, it may contain excessive pressure which must be relieved before tapping. A hissing noise is expected. 6. Turn in a new 16g CO2 capsule with thread type of 3/8-24UNF, turn clockwise rmly into the regulator base. 4. Slowly turn the regulator knob in clockwise direction to 5 PSI, and stop for 2 seconds ad turn o regulator.