Pyle PL1101HRGR PL1101HRBK Manual 1 - Page 3

Universal, Headrest, Pre-installed, Monitor Owner's Manual - electronics

Page 3 highlights

UNIVERSAL HEADREST WITH PRE-INSTALLED MONITOR OWNER'S MANUAL Congratulations on your purchase of this headrest monitor system. The product is designed and built to deliver excellent video quality and long lasting high performance. For best results please consult a professional mobile electronics installer for application advice or troubleshooting. Please read these instructions thoroughly before installation. Installation Instructions 1. Remove the existing headrest from the seat. 2. Adjust the posts of the new headrest to fit the holes in the seat where the headrest will be installed. The post can be moved together or apart: grasp one post in each hand, move the posts in opposing directions (like they were walking) while pushing them toward each other or away from each other. 3. Insert the cable in the proper hole. Insert the posts into the holes in the seat and carefully work the headrest into position. Make sure the cable is not pinched. 4. Run the cable down the seat and out to the location of the video source unit (such as a DVD player). 5. Connect the wires as indicated: a. Red: Connect to a switched (+) 12 volt source (ACC). Use a lead that has (+) 12V when the ignition is on or in the ACC position so the monitors turn off when the key is in the off position. Wiring the monitors "hot" could cause your battery to run down when the engine is not running. b. Black: Connect to a good chassis ground. c. Reversing the polarity of the red and black leads will damage the monitor. d. Connect the video input connector to the video output from the source unit (Le.DVD player). e. Test the system. 2

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8

UNIVERSAL
HEADREST
WITH
PRE-INSTALLED
MONITOR OWNER'S MANUAL
Congratulations
on
your purchase
of
this headrest monitor system. The
product
is
designed and built to deliver excellent video quality and long
lasting high performance. For best results please consult a professional
mobile electronics installer for application advice
or
troubleshooting.
Please read these instructions thoroughly before installation.
Installation Instructions
1.
Remove the existing headrest from the seat.
2. Adjust the posts of the new headrest to fit the holes in the seat where
the headrest will
be
installed. The post can
be
moved together or
apart: grasp one post
in
each hand, move the posts
in
opposing
directions (like they were walking) while pushing them toward each
other or away from each other.
3.
Insert the cable
in
the proper hole. Insert the posts into the holes
in
the seat and carefully work the headrest into position. Make sure the
cable
is
not pinched.
4. Run the cable down the seat and out to the location of the video
source unit (such as a
DVD
player).
5.
Connect the wires as indicated:
a.
Red: Connect to a switched
(+)
12 volt source (ACC). Use a lead
that has
(+)
12V when the ignition is
on
or
in
the ACC position so
the monitors turn off when the key
is
in
the off position. Wiring the
monitors "hot" could cause your battery to
run
down when the
engine is not running.
b.
Black: Connect to a good chassis ground.
c.
Reversing the polarity of the
red
and black leads will damage the
monitor.
d.
Connect the video input connector to the video output from the
source unit (Le.DVD player).
e.
Test the system.