Pyle PLCD13MR PLCD13MR Manual 1 - Page 9

OPERATION SWITCHING ON/OFF THE UNIT press the button (17) to change hours Switch on the unit by pressing any button or button (16) to change minutes. (except button (7) and button (4)). When system is on, press button (9) to turn off the unit. MUTE In radio and AUX mode, press MUTE button (3) to mute down sound. Press it FACEPLATE RELEASE Press button (7) to detach the again to release this mode and recover previous volume level. removable faceplate. EQUALIZATION SOUND ADJUSTMENT Press SEL button (10) to select the desired adjustment mode. The adjustment mode will change in the following order: Press EQ button (19) to turn on equalization function and to select desired audio mode. There are five kinds of mode as below: VOL BAS TRE BAL FAD FLAT CLASSICS POP M ROCK M DSP OFF (Volume) (Bass) (Treble) (Balance) (Fader) DISPLAY (8) Pressing the VOL +/- button (11), it is Exhibit current frequency and activated possible to adjust the desired sound functions on the display (8). quality. Press and hold the SEL button (10) for several seconds to enter into the selection for the situation of beep sound, then press the VOL +/- (11) to select as AUXILIARY INPUT The unit can be connected to a portable audio player through the AUX IN jack (12). follows: REMOTE SENSOR BEEP 2ND BEEP ALL BEEP OFF Point the remote control handset to the remote sensor IR (26). Press the function - BEEP 2'nd mode: The beep is only generated when keys on the handset to control the system. all allowed double function button ESP FUNCTION is pressed long (several seconds). If the unit has the electronic shockproof e.g. function, it can be shockproof about When preset button is pressed. several tens of seconds. When BND/LOUD button (13) is pressed. When AMS button (18) is pressed. - BEEP ALL mode: The beep is generated when every key is pressed. - BEEP OFF mode: The beep is disabled. RESET FUNCTION RESET button (24) must be activated with either a ballpoint pen or thin metal object. The RESET button is to be activated for the following reasons: - Initial installation of the unit when all wiring is completed. LOUDNESS - All the function buttons do not operate. Press BND/LOUD button (13) for - Error symbol on the display. several seconds to reinforce the bass Note: If press RESET button (24), the output. Press it for several seconds again unit can't work yet, please use a cotton to release this function. swab soaked in isopropyl alcohol to clean DISPLAY the socket on the front panel. Press the DISP button (15), the clock is shown on the display. Then hold down the button until the clock flashes. Then 9