Pyle PLDN74BT Owners Manual - Page 11

Troubleshooting Phenomenon Not operating Reasons Fuse of machine power supply and auto vehicleEattery is burnt; Voltage of power supply is overloaded; Automatic protection system avoids fault due to illegal operation Solutions Change for fuse of the correct types; Adjust voltage; Reset the system by pressing the Reset key No or low sound Remote control doesn't work Disconnection; Volume setting is low volume; Loudspeaker fault Big deviation of volume balance setting; Earthing in loudspeaker conection Battery is out of power; Battery is not placed correctly Inferior quality Inferior disc is prohibited; Check the connection; increase volume Adjust the volume balance setting to middle place; Keep insulation of loudspeaker connection Change new battery; Reinstall battery; Use genuine discs; of sound; Loudspeaker does not match impedance Change a matched loudspeaker; Distortion of sound of the machine; Speaker fault Check the connection of loudspeaker. Machine reset Connection of ACC and B+ is not correct. Check and reconnect ACC and by itself when it B+ is shut down No image Unstable output of image Connection of brake wire is not correct; Not braking state. DVD does not correspond with the present system video setting; Video signal line is not connected correctly. Check brake wire and connect them corerectly; Keep braking state after the car is placed safely Adjust systerm video setting; Check and replace video signal line. Image Incorrect ratio settings of icons Use correct ratio settings of stretching or icons compressing Weak signal Auto antenna does not reach out completely Connect auto antenna line LOC function is under working state. correctly Close LCC function