Pyle PMX602M PMX402M Manual 1 - Page 7
C. Connections
 |
View all Pyle PMX602M manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
7. CHANGE-OVER SWITCH This device is used to 110V/220V or 115V/230V voltage conversion. 8. AC POWER CORD/FUSE HOLDERS For selecting the proper voltage (115/230AC) to match the power supply in your area. Note: To avoid damage to your unit, always make sure this switch is set to the correct supply voltage. Damage caused by improper use is not covered by the warranty C. CONNECTIONS You will need a lot of cables for different purposes - see the following figures to make sure you have got the right cables. Unbalanced equipment may be connected to a balanced inputs/outputs. Either use mono 1/4 plugs or connect ring and sleeve of TRS plugs. Fig. 5: Balance plug 6
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
 |
 |
7. CHANGE-OVER SWITCH
This device is used to 110V/220V or 115V/230V voltage conversion.
8. AC POWER CORD/FUSE HOLDERS
For selecting the proper voltage (115/230AC) to match the power supply in your area.
Note: To avoid damage to your unit, always make sure this switch is set to the correct
supply voltage. Damage caused by improper use is not covered by the warranty
C. CONNECTIONS
You will need a lot of cables for different purposes – see the following figures to
make sure you have got the right cables. Unbalanced equipment may be connected to
a balanced inputs/outputs. Either use mono 1/4
plugs or connect ring and sleeve of
TRS plugs.
Fig. 5: Balance plug
___________________________________6________________________________