Pyle PRJELMT86 Instruction Manual - Page 1

Pyle PRJELMT86 Manual

Page 1 highlights

INSTALLATION AND USAGE OF ELECTRIC SCREEN: 1. Carefully remove the screen after opening the box. Be careful not to damage the surface of the screen or its housing during this process. 2. According to projecting requirements, fix up the wall shelf securely. (Note that the two wall shelves must be at the same height, otherwise screen surface will be slanted to one side) 3. Carefully hang the screen on the wall shelf. 4. Once installation is complete, a red light will show on the switch box when the screen is powered on. Press the UP and DOWN switch on the switch box to make sure the screen functions normally. 5. Use either the wired, or included wireless remote to control the screen according to your preference. HANGING HOOK SCREEN HOUSING WIRED REMOTE WALL MOUNT: NAIL There is a key ring on the bracket at both ends of the screen, when you need to hang projection screen on the wall, you should WALL hammer down nails or install screws at the corresponding position on the wall first, then hang up the screen. SCREEN DIRECTION SCREEN HOUSING CEILING MOUNT: When you need to hang projection screen on the ceiling, you should install two pieces of pothooks at the corresponding position on the ceiling first, then latch on hanging hook which is on the end cap of projection screen. POTHOOK CEILING HANGING HOOK SCREEN HOUSING SCREEN DIRECTION REMOTE USAGE: Press the UP button to raise the screen and the DOWN button to lower the screen for viewing. Press STOP at any point to position the screen anywhere in between its highest and lowest position * NOTE: Screen can be controlled by both wired and wireless controllers

  • 1
  • 2

INSTALLATION AND USAGE OF ELECTRIC SCREEN:
When you need to hang projection
screen on the ceiling, you should
install two pieces of pothooks at
the corresponding position on the
ceiling first, then latch on hanging
hook which is on the end cap of
projection screen.
CEILING MOUNT:
Press the
UP
button to raise the
screen and the
DOWN
button to
lower the screen for viewing. Press
STOP
at any point to position the
screen anywhere in between its
highest and lowest position
* NOTE: Screen can be controlled by both wired and
wireless controllers
REMOTE USAGE:
WALL MOUNT:
There is a key ring on the bracket
at both ends of the screen, when
you need to hang projection
screen on the wall, you should
hammer down nails or install
screws
at
the
corresponding
position on the wall first, then
hang up the screen.
Carefully remove the screen after opening the box. Be careful
not to damage the surface of the screen or its housing during
this process.
According to projecting requirements, fix up the wall shelf
securely.
(Note that the two wall shelves must be at the same
height, otherwise screen surface will be slanted to one side)
Carefully hang the screen on the wall shelf.
Once installation is complete, a red light will show on the switch box
when the screen is powered on. Press the
UP
and
DOWN
switch on
the switch box to make sure the screen functions normally.
Use either the wired, or included wireless remote to control the
screen according to your preference.
1.
2.
3.
4.
5.
NAIL
WALL
SCREEN DIRECTION
SCREEN
HOUSING
SCREEN DIRECTION
SCREEN
HOUSING
CEILING
POTHOOK
HANGING
HOOK
SCREEN
HOUSING
WIRED
REMOTE
HANGING
HOOK