Pyle PRJLE60 PRJLE60 Manual 1 - Page 7

Trouble shooting Problem: No power Remote Control Does not function No image Projector turns off Automatically Possible solution(s): 1, Check the power cable. 2, Do not open the projector . 3, Broken fuse 1,Allow 5 minutes(between on and off sessions) 2,Check for defective batteries.Replace if needed. 3, Aim directly towards the IR receiver. 1, Make sure lens cap is removed. 2, Check power cable and source 3, Check input signal. 4, The motherboard may be broken .Replace it If needed. 1, Dirty Filter ,Please rinse filter with water . 2, Due to faulty fans. Eg: fans stopped , Heat sensitive system. Replace the fan Immediately when needed. 12 Installation Installation method: Contact a proffessional service technitian to mount this projector to a ceiling. Follow the instructions belowe for the correct projector positions: screen projector projector screen screen projector Front projection ceiling mount Rear projection Ceiling mount Front projection Table mount Warning 1 To avoid damage beyond repair or bodily injury,secure projector mounts firmly to the ceiling or a stable surface. 2) This projector can only be used in an environment with a temperature not exceeding the range of 0- 35 degree .The projector may malfunction if temperatures vary outside the normal operating range. 3 The sharpness of the screen might be interrupted when the projector is being used in a dusty,wet,moist or smoke filled environment. The projector might malfunction in a moist or wet environment. 4 Proper ventilation avoids overheating the projector. 5 projector screen Rear projection Table mount