Pyle PRJOS100 Instruction Manual - Page 2

Installation Steps (Reverse operation when disassembling) 1. Install the vertical rod and feet base. 2. Put screen sides of the screen into the vertical pole. 3. Insert the upper transverse pole and corner connector. Vertical rod Vertical rod 4. Insert the corner connector into the vertical poles on both sides 5. Push the vertical rod to both sides to make the screen equal width up and down. 6. Fill the water bag with water and press it on both sides of the feet base. Outdoor Use Note: If the outdoor wind power exceeds level 2, this product cannot be used to avoid personal injury or product damage! Use a water bag when there is no wind; when you use it outdoors, use a ropes to tie both sides of the screen to adjust the position of the bolt and the length of the ropes (as shown in the picture). Rope Stake Note: Stake cannot be used on hard ground. Rope Stake Rope Stake Rope Stake www.PyleUSA.com