Pyle PRJS1696 PRJS43100 Manual 1 - Page 4

the manual switch

Get Pyle PRJS1696 PDF manuals and user guides View all Pyle PRJS1696 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 4 highlights

-03- 4. INSTALLING a. Unpack the screen carefully. be sure the screen is in good condition, check all the accessories are packed inside the carton. b. Check the voltage and frequency marked on the screen is in accordance with the local power supply. It is suggested only to use the screens indoor under normal temperature and humidity. c. Refer to the below and fix the screen to wall or to the ceiling. fix the screen to the wall. fix the screen to the ceiling. d.Plug in the power supply. Press the down button of the manual switch or the transmitter ,the screen will go down smoothly. Press the stop button when the screen goes down to the expected position,otherwise the screen will stop at the lower limited position automatically. J.1~~~~t~~~"",r # # ~ rl~~~~~~~~jdi e.Press the up button of the manu::itch or the transmitter I the screen will go I up Smoothly. Press the stop button when t the screen goes up to the expected "F~~~~~~~jdi position, otherwise the screen will roll me back to the housing. The screen won't be used for a long time when you cut off the power supply. Don not pull the control wires to avoid disconnection and it's dangerous. f. Moving Parts of the drive must be installed higher than 2,5 mm above the floor or other level that could provide access to it.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
-03-
4.
INSTALLING
a.
Unpack
the
screen
carefully.
be
sure
the
screen
is
in
good
condition,
check
all
the
accessories
are
packed
inside
the
carton.
b.
Check
the
voltage
and
frequency
marked
on
the
screen
is
in
accordance
with
the local power supply.
It
is
suggested only
to
use
the
screens
indoor
under
normal
temperature
and
humidity.
c.
Refer
to
the
below
and
fix
the
screen
to
wall
or
to
the
ceiling.
fix
the screen
to
the wall.
fix
the
screen
to
the ceiling.
d.Plug in the power supply. Press the down button
of
the manual switch
or
the transmitter ,the screen will go down
smoothly. Press
the stop button
when
the
screen
goes down to the
expected
position,otherwise the
screen will stop
at
the lower limited position automatically.
#
#
~
rl~~~~~~~~jdi
e.Press
the
up
button
of
the
manu::itch
J.1~~~~~~~"",r
or
the
transmitter
I
the
screen
will
go
I
t
up
Smoothly.
Press
the
stop
button
when
t
the
screen
goes
up
to
the
expected
"F~~~~~~~jdi
position,
otherwise the screen
will
roll
me
back
to
the
housing.
The
screen won't be used for a long time
when you cut
off
the
power supply.
Don
not
pull
the
control
wires
to
avoid
disconnection and it's dangerous.
f.
Moving
Parts
of
the
drive
must
be
installed
higher
than
2,5
mm
above
the
floor
or
other
level
that
could
provide
access
to
it.