Pyle PRJSE168 PRJS43100 Manual 1 - Page 5
Remote, Control, System
View all Pyle PRJSE168 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
-04- 5 WARNINGS a.The screen can not be folded. Do not use fingers or hard objects to touch the screen surface Do not splash the milk fruit juice or other chemical doses to the screen surface. Keep the screen far away from the high temperature objects or fire. b.!f the screen is dirty. wash the screen gently by a broom or a cotton ball,do not use the organic solvents to clean the screen surface. c.When pulling the screen down, must be slowly and vertical.Do not pull it roughly. please stop pulling as soon as the black border is out or the screen is jammed or injured then send the screen to the maintenance center. d.After using put the screen back to the housing in order to avoid being polluled. ~ not using ij for a long time, please take the screen from the wall and pack it in a carton. e. If the power soft cable was broken, you have to replace it by technical people from the manufacturer or service department ensure safety. WARNINGS Important safety instructions. It is important for the safety of persons to Follow these instructions. Save these instructions. - do not allow children to play with fixed controls. Keep remote controls away from children; - Frequently examine the installation for imbalance and signs of wear or damage to cables and springs. Do not use if repair or adjustment is necessary; If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance. 6. REMOTE CONTROL SYSTEM 1.lhe remote control can be IR Type or RF Type. 2. (A-IR Type) Plug in the power cable for the controller. the power source indicator will flash. After the stop button of the remote control is pressed and either the up or down button is pressed again, the power relay of the controller will start to operate. Press the stop button after eight seconds, the power source indicator will stop flashing. This is evidence that the controller has finished automatic learning successfully. Above operation is normally completed in eight seconds. (B-RF Type)Press the down button, then plug in the power source indicator will flash. After the stop button of the remote control is pressed. The down button is pressed again,the power relay of the controller will start to operate. Press the stop button, after eight seconds, the power source indicator will stop flashing. This is evidence that the controller has finished automaticlearningsuccessfully,Above operation is normally completed in eight seconds.