Pyle PRJSER1696 PRJS43100 Manual 1 - Page 4
the manual switch
View all Pyle PRJSER1696 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
-03- 4. INSTALLING a. Unpack the screen carefully. be sure the screen is in good condition, check all the accessories are packed inside the carton. b. Check the voltage and frequency marked on the screen is in accordance with the local power supply. It is suggested only to use the screens indoor under normal temperature and humidity. c. Refer to the below and fix the screen to wall or to the ceiling. fix the screen to the wall. fix the screen to the ceiling. d.Plug in the power supply. Press the down button of the manual switch or the transmitter ,the screen will go down smoothly. Press the stop button when the screen goes down to the expected position,otherwise the screen will stop at the lower limited position automatically. J.1~~~~t~~~"",r # # ~ rl~~~~~~~~jdi e.Press the up button of the manu::itch or the transmitter I the screen will go I up Smoothly. Press the stop button when t the screen goes up to the expected "F~~~~~~~jdi position, otherwise the screen will roll me back to the housing. The screen won't be used for a long time when you cut off the power supply. Don not pull the control wires to avoid disconnection and it's dangerous. f. Moving Parts of the drive must be installed higher than 2,5 mm above the floor or other level that could provide access to it.