Pyle PSBV200BT PSBV200BT Manual 1 - Page 12

2. LISTEN TO FM RADIO Connect the supplied 3.5mm audio cable to FM ANT jack on the rear of the unit as the figure below. Extend the wire and relocate it to get the best reception. PC/MP3 AUX 1 AUX 2 L INPUT SELECT R DC:18V/2.5A 1. Power ON the unit as previous procedures. 2. Press the INPUT button on the unit or remote control repeatedly until FM frequency appears on the display. 3. Press or button on remote control repeatedly to search the specific radio stations. (To search the radio stations in auto mode: Press and hold or button two seconds then release the button. The unit will auto search the next available radio station then stop. Repeat above procedure to search all available radio stations.) 4. To store the current received radio station into the memory. Press the MEMORY( ) button on the remote control, CH 01 will appear on the display. Press the CH+/CH- buttons repeatedly to select channel number as desired. Press the MEMORY button again to stored the current radio station to the selected channel. 5. To listen the preset channels, press the CH+/CH- buttons on the remote control repeatedly until the desired channel appears on the display. 6. Press the EQ button on the remote control repeatedly to select stereo or mono as desired. STEREO or MONO will appear on the display 7. Press the SCAN button on the remote control to auto search the working radio station and auto store in memory then press CH+ or CH- to choose the desired radio station. 11