Pyle PT570AU PT570AU Manual 1 - Page 5

Using the Remote Control 1 POWER 2 SCAN Memory 12 3 FM AM DVD AUX1 AUX2 AUX3 USB/SD 13 4 5 6 7 8 9 10 11 2.1CH 3.1CH 5.1CH DSP TreB+ Bass + VOL+ L MUTE R TreB VOL Bass Play For USB/SD Paus e Side Left Vol. Center Vol. Side Right Vol. SW Vol. 14 15 16 17 18 19 20 21 22 PT570AU Digital 5.1 Channel Receiver 1.Power on/off control selector 2.Tuner band control selector 3.Tuner memory selector 4.Channel source output selector 5.Treble volume increase selector 6.Left balance selector 7.Treble volume decrease selector 8.USB/SD play selector 9.USB/SD-skip selector 10.Side left volume adjustment selector 11.Center volume adjustment selector 12.Tuner number selector 13.Input mode selector 14.DSP control selector(live, hall, church) 15.Bass volume increase selector 16."Mute mode" control selector 17.Master volume control selector 18.Right balance selector 19.Bass volume decrease selector 20.USB/SD pause selector 21.Side right volume adjustment selector 22.Subwoofer volume adjustment selector Battery Installation 1.On the back of the remote control, push the tab and lift off the battery cover. 2.Obtain two (2) fully-charged AAA batteries. Match the "+" and "-" marks on the batteries to the "+" and "-" marks in the battery case, then insert the new batteries. 3.Align the cover keys with the case holes and press the cover back into place. The tab should click when the cover is locked. 4.Test the unit by pressing POWER or any mode key. If the batteries are inserted correctly, the selected mode key will blink once. Note Do not leave the remote control in an extremely hot or humid place. Do not use a new battery with old ones. Do not mix manganese batteries with other kinds of batteries. Do not expose the remote sensor to direct sunlight or lighting apparatuses. Doing so may cause a malfunction. If you do not intend to use the remote control for an extended period of time, remove the batteries to avoid possible damage from battery leakage and corrosion. .3.