Pyle PT588AB PT588AB Manual 1 - Page 5

Using the Remote Control 1 3 4 5 6 7 8 9 10 11 12 13 14 2 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 1.Power on/off control selector 2.HDMI audio switch selector 3.Tuner band control selector 4.Tuner memory selector 5.Tuner mono/stereo audio output selector 6.Side left volume adjustment selector 7.Center volume adjustment selector 8.Treble volume increase selector 9.Left balance selector 10.Treble volume decrease selector 11.Bluetooth pairing selector 12.Delay time selector 13.Mic1 volume adjustment selector 14.Mic treble volume adjustment selector 15.Tuner number selector 16.Channel source output Selector(2.1CH,3.1CH,5.1CH,) 17.DSP control selector(live, hall, church) 18.Input mode selector 19.Side right volume adjustment selector 20.Subwoofer volume adjustment selector 21.Bass volume increase selector 22."Mute mode" control selector 23.Master volume control selector 24.Right balance selector 25.Bass volume decrease selector 26.Bluetooth pause selector 27.Bluetooth-skip selector 28.Mic ECHO adjustment selector 29.Mic2 volume adjustment selector 30.Mic Bass volume adjustment selector Howto Pair the bluetooth receiver The Amplifier have built in a bluetooth receiver. If you need to pair with a bluetooth sender(mobile phone), first open the subwoofer, and press the "Pairing"key on the remote control, the VFD will show" pairing "and flicker. Then search the bluetooth receiver(Device ID:HDKA-2100) by your own bluetooth sender and connect themby the password:0000. After that, you can enjoy the music by the bluetooth receiver. The system will turn to the normal working statue if no paring in 10 minutes. Battery Installation 1.On the back of the remote control, push the tab and lift off the battery cover. 2.Obtain two (2) fully-charged AAA batteries. Match the "+" and "-" marks on the batteries to the "+" and "-" marks in the battery case, then insert the new batteries. 3.Align the cover keys with the case holes and press the cover back into place. The tab should click when the cover is locked. 4.Test the unit by pressing POWER or any mode key. If the batteries are inserted correctly, the selected mode key will blink once. Note Do not leave the remote control in an extremely hot or humid place. Do not use a new battery with old ones. Do not mix manganese batteries with other kinds of batteries. Do not expose the remote sensor to direct sunlight or lighting apparatuses. Doing so may cause a malfunction. If you do not intend to use the remote control for an extended period of time, remove the batteries to avoid possible damage from battery leakage and corrosion. .3.