Pyle PT798SBA PT798SBA Manual 1 - Page 13
Radio - new
View all Pyle PT798SBA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
TheFM/AM reception ill poor. Radio stations cannot be tuned in. The remote cODtrol does DOt function. Error messages Protect Ifyou are unable to remedy the problem uUng the troubleshooting guide Ifthe problem persist Radio Need outdoor antenna. Check that the antennas are connected securely. The signal strength ofthe stations is too weak (when tuning in with automatic tuning). No stations have been preset or the preset stations have bocn cleared (tuning by scanning preset stations). Obstacles exist between the remote and the receiver. The remote batteries are weak. Incorrect input selection on the remote control. Ifappears a message, there may be a malfunction. Should any problems persist. Irregular current is output to the speakers. The receiver will automatically turn off after a few seconds. SttelCh 1he FM/AM antenna of the receiver in the rear panel. But please don't connect the receiver to an outdoor PM/AM antenna on raining days. Adjust the antennas and connect an external antenna, ifnecessary. Adjust manually Make sure you set the tuning interval correctly. Remove any obstacles in the path between the remote and the receiver. Replace all batteries in the remote control with new ones. Make sure you select the correct input on the remote control. You can check the condition of the system by the message. Consult your nearest dealer. Check. the speaker connection then turn on the power again. Clearing the receiver's memory may remedy the problem. Note that all memorized settings will be reset to their initial settings (11 the receiver. Thke the complete appliance to the nearest dealer for advice. • 11 •