Pyle PT990A PT990A Manual 1 - Page 6

REMOTE CONTROLLER By using the provided remote control unit, the receiver can be controlled from your listening position. To use the remote control unit, point it at the REMOTE SENSOR window of the receiver. Notes: - Even if the remote control unit is operated within the effective range, remote control operation may be impossible if there are any obstacles between the unit and the remote control. - If the remote control unit is operated near other appliance which generate infrared rays, or if other remote control devices using infrared rays are used near the unit, it may operate incorrectly. - The power is turned on/off (standby) by pressing the POWER button on the remote control unit in standby mode. Precautions concerning batteries -Be sure to insert the batteries with correct positive+ and negative - polarities. - Use batteries of the same type. Never use different types of batteries together. - Rechargeable and non-rechargeable batteries can be used. Refer to the precautions on their labels. - When the remote control unit is not to be used for a long time (more than a month), remove the batteries from the remote control unit to prevent them from leaking. If they leak, wipe away the liquid inside the battery compartment and replace the batteries with new ones. - Do not heat or disassemble batteries and never dispose of old batteries by throwing them in a fire. REMOTE CONTROL OPERATION RANGE Use the remote control unit within a range of about 7 meters (23 feet) and the angles of up to 30 degrees aiming at the remote sensor. BATTERY INSTALLATION 1. Remove the battery compartment cover. 2. Insert two "AA" dry batteries. Make sure that the batteries are inserted with their positive "+" and negative "-" poles positioned correctly. 3. Close the cover until it clicks. If the distance required between the remote control unit and main unit decreases, the batteries are exhausted. In this case, replace the batteries with new one 4