Pyle PWMA4004BT Instruction Manual - Page 7
How to replace the preset radio stations?, SAFETY INSTRUCTIONS
View all Pyle PWMA4004BT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
How to replace the preset radio stations? • Use the remote control to set the radio stations. • Use button of the front panel set the radio stations. NOTE: The preset stations can't be deleted, BUT CAN BE REPLACED. Operations Steps 1. Rotate the input selector switch to the BT/MP3/AM/FM/OPTI/COAX position. 2. Press the Mode key of the front panel or remote to select AM/FM. 3. / : Press the button to adjust to your favorite station number, then, press and hold this button to auto scan the programs downward or upward, It will not stop until the tuner is found, and the tuner will automatic replace your favorite station number. In this way, you can replace the preset radio stations. SAFETY INSTRUCTIONS 1. Make sure that all connections are properly connected and the main volume is set to minimum level before turning ON the unit. 2. When more than one pair of speakers are used, (specially the main speaker output) make sure that the speakers used are of the same wattage and impedance, otherwise the unit maybe damaged under high power or long term operation. 3. To avoid humming sounds and unwanted noise, make sure that all the wires are properly inserted 4. For speaker cords, strip o the vinyl coating and twist the wire tip. Push down the pink jack or loosen the screw terminal, before inserting the wire tip, then fasten it and tighten the screw. Be careful not to let the wires stick out ofthe terminal otherwise this may cause a short circuit when wires of di erent terminal contact each other. 5. After the unit is turned ON, adjust the main volume to the desired level same with the bass and treble volume, etc. www.PyleUSA.com 7