RCA 27F520T User Guide & Warranty - Page 6

Basic Antenna Connection A combination antenna receives normal broadcast channels (VHF 2-13 AND UHF 14-69). Your connection is easy since you will connect the antenna to the 75 OHM ANTENNA INPUT jack on the rear of the TV. If your antenna has a round cable (75 ohm) on the end, then you are ready to connect it to the TV. Go to the next step. If your antenna has flat twin-lead wire (300 ohm), you first need to attach the antenna wires to the screws on a 300 to 75 ohm adapter (not supplied with your TV). Push the round end of the adapter or antenna cable onto the 75 OHM ANTENNA INPUT jack on the rear of the TV. If the round end of the antenna cable is threaded, screw it down tight. Plug the TV's power cord into a power outlet and turn on the TV. Set TV/CATV to TV mode as detailed on page 12. Refer to AUTO SEARCH to set up your available TV channels. Details are on page 13. Before plugging the UHF/VHF Rod Antenna into the ANTENNA INPUT jack, check that the pin is not bent. If it is bent, straighten the pin as illustrated, then plug the pin into the jack. Bent pin Cable Plug (Needs to be straightened) (Straight pin) FCC WARNING -This equipment may generate or use radio frequency energy. Changes or modifications to this equipment may cause harmful interference unless the modifications are expressly approved in the instruction Manual. The user could lose the authority to operate this equipment if an unauthorized change or modification is made. VHF Antenna (Not supplied) UHF Antenna (Not supplied) VHF/UHF Combiner (Not supplied OR CATV Box* or Satellite Box (Not supplied) *Some cable TV systems use scrambled signals and require a special converter to receive these channels. Consult your local cable company. ANT. IN OUT IN 75-ohm Coaxial Cable OR From Cable System or Satellite Antenna 75-ohm Coaxial Cable From Cable System VHF/UHF Combination Antenna (Not supplied) Note to CATV system installer: This reminder is provided to call the CATV system installer's attention to Article 820-40 of the NEC (Section 54 of the Canadian Electrical Code, Part 1) that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building as close to the point of cable entry as practical. CABLE TV / ANTENNA CONNECTIONS Helpful Hints If you have separate UHF and VHF antennas, you need an optional combiner to connect the antennas to the TV.