RCA DRD420RE User Guide - Page 21
Using the Remote to Control a Device, Modes of Operation, Controlling a Second Satellite Receiver - codes
UPC - 034909971062
View all RCA DRD420RE manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
Using the Remote Using Direct Entry 1. Turn on the device to be programmed. 2. Look up the brand and code number(s) for the device on the code list at the end of this section. 3. On your remote control, press and hold the device button you want to program. 4. Enter a code from the code list. 5. Release the device button, and then press ON•OFF to see if the device responds to the remote control commands. If it doesn't, try pressing the device button and then ON•OFF again. 6. If you get no response, repeat these steps using the next code listed for your brand, until the device responds to the remote control. This remote control may not operate all models of the brands that are shown. Use the codes shown in this manual, or on the sheet packed with your remote. Using the Remote to Control a Device Once the remote has been programmed successfully, you are ready to use it to control your devices. To operate the device: 1. Press the device button (TV, VCR, DIRECTV, VCR2 or AUX) to set the remote to control the device. 2. Press ON•OFF to turn the device on or off. 3. Use the remote control buttons that apply to that device. • If your remote is programmed to control a VCR, you only need to press the RECORD button to begin recording from video. Modes of Operation Because this universal remote can control several different devices (DVD player, VCR, cable box, etc.) it uses operational modes triggered by the device buttons. For example, if you wanted the remote to control the TV, you would press the TV button to put the remote into TV mode. Then, if you want to play a videotape, press VCR, then PLAY (pointing the remote control at the VCR). Controlling a Second Satellite Receiver The remote can control two satellite receivers. From the Main menu, select Options, then System Options, then Remote Setup. Then follow the on-screen instructions and enter the appropriate code from the Satellite Receiver list at the end of this section. By default, the DIRECTV button is used to control the first satellite receiver and the AUX button is used to control the second satellite receiver. If your second receiver is an RCA, GE, or Proscan and you want to control it using the AUX button, use code 5001. Code 5000 is used by the DIRECTV button. 19