RCA RACE6011-6COM English Manual - Page 15

6. Eco Button: When the unit is in ECO mode, the light will turn on. In ECO mode, the unit will Cool Mode: The cooling function allows the air turn off once the room is cooled to the user set conditioner to cool the room and at the same time reduces air humidity. Press the MODE button to activate the cooling function. To optimize the function of the air conditioner, adjust the temperature and the speed by pressing the button indicated. temperature. Fan will also be off at this point. The unit will turn back on when the room temperature rises above the user set temperature. Before the compressor starts, the fan motor will run for a while, then it will stop for a while, and will Dry Mode: This function reduces the humidity of repeat to provide a much more comfortable feeling the air to make the room more comfortable. Press and save energy. the MODE button to set the DRY mode. An automatic function of alternating cooling cycles 7. Sleep Button: Press the SLEEP button, all of the and air fan is activated. display lights will turn off after a while, but the Fan Mode: This function only works when the air conditioner is vented. Press the MODE button to set the FAN mode. With pressing the FAN SPEED button, the speed changes in the following Sleep light is always on. In SLEEP mode, the air conditioner will automatically adjust the temperature and fan speed to make the room sequence: Hi, Med and Lo in FAN mode. more comfortable during the night. The set Auto Mode: In AUTO mode the unit automatically chooses the mode of operation (COOL,DRY or FAN).In this mode the temperature will be set according to the room temperature (tested by the temperature sensor which is incorporated in the indoor unit.). temperature will automatically raise every 30-60 minutes, and at most change six times until the set temperature is 81 or 82 . 8. Fan Speed Button: Press the FAN SPEED button 5. Timer Button:Use these buttons on the control panel and remote to set the Timer. Timer Off: The timed stop is programmed by to choose the fan speed options. You can choose Hi, Med, Lo or auto speed in COOL mode or choose Hi, Med, Lo in FAN mode. pressing TIMER button. Set the rest time by pressing the button or until the rest time displayed is to your liking then press TIMER button again. Timer On: When the unit is off, press TIMER 9. Filter Button: When the Filter Check light is off, it is not necessary to press the Filter Check button. When the Filter Check light is on, you can turn off the light by pressing the Filter Check button. After button , set the temperature with the fan motor works for 500 total hours, the Filter pressing the button or . Press TIMER button a second time, set the rest time with pressing the button or . Press TIMER Check light will turn on to remind the user to clean the filter. button a third time, confirm the setting, then will 10.Directional Louvers: To direct the airflow, use the automatically switch on and will show on the display. horizontal wheel to control the horizontal direction Note: It can be set to automatically turn off or on in 0.5-24 hour increments. Each press of the buttons will increase or decrease the timer. and use the air deflectors to control the vertical direction. The Timer can be set in 0.5 hours increment below 10 hours and 1 hour increment for 10 hours or above. The SET light will turn on while setting. To cancel the set function, press the TIMER button again. air deflector horizontal wheel air deflector 13