RCA RCR4383 Owners Manual - Page 1
RCA RCR4383 Manual
View all RCA RCR4383 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
RCR4283 / RCR4383 Universal Remote Control Owner's Manual Manual del Propietario (parte posterior) INFO key displays information for the component you're controlling Transport keys, including SKIP and SLOW, give you better DVD/DVR control Actual model may vary from picture shown Component keys (TV, SAT•CBL, DVD•VCR, DVR•AUX) Dedicated MENU and GUIDE keys let you access advanced component functions Arrow keys for navigating your components' menu systems The INPUT and - (dash) key has three functions: (1) it toggles through all the video sources connected to your TV; (2) when the remote is in VCR mode, this button toggles between VCR and the TV input; (3) when you're entering digital channel numbers directly, this button lets you separate the main channel number from the subchannel number Care and Maintenance • Keep the remote dry. If it gets wet, wipe it dry immediately. • Use and store the remote only in normal temperature environments. • Handle the remote gently and carefully. Don't drop it. • Keep the remote away from dust and dirt. • Wipe the remote with a damp cloth occasionally to keep it looking new. • Modifying or tampering with the remote's internal components can cause malfunction and invalidate its warranty. Four-Component Universal Remote Congratulations on your purchase of this four-component universal remote. This universal remote controls up to four electronic components and makes juggling remote controls a thing of the past. Your remote is guaranteed to work with all brands of components. This remote is unusually versatile because it has a DVR•AUX key that you can program to control any video component. The four-component universal remote is easy to use, easy to program and gives you control at the touch of your fingertips. SAVE THIS MANUAL AND THE CODE LISTS! Remote controls can sometimes lose their programming when you change the batteries. Make sure you keep the manual and code lists in a safe place so that you can reprogram the remote if you need to. Tip: The four-component universal remote is already programmed to operate most RCA, GE and PROSCAN branded TVs, VCRs, DVD players and satellite receivers. Just press the corresponding key-DVD•VCR for a DVD player, TV for a television, SAT•CBL for a satellite receiver, DVR•AUX for a DVR. Battery Installation and Information Your universal remote requires two AAA alkaline batteries (batteries may or may not be included, depending on model). To install the batteries: 1. Press and push the battery compartment cover to remove it.. 2. Insert the batteries, matching the batteries to the (+) and (-) marks inside the battery compartment. 3. Push the battery cover back into place. Note: If you are replacing batteries, try not to press any buttons after you've taken the old batteries out. Pressing buttons while replacing batteries causes the remote to lose the devices you've programmed. You will need to program the remote again. Battery Precautions: • Do not mix old and new batteries. • Do not mix alkaline, standard (carbon-zinc) or rechargeable (nickelcadmium) batteries. • Always remove old, weak or worn-out batteries promptly and recycle or dispose of them in accordance with Local and National Regulations. Battery Saver Your universal remote control saves battery power by automatically turning off if any key is pressed for more than 60 seconds. This saves your battery life should your remote get stuck in a place where the keys remain depressed, such as between sofa cushions. Programming Your Remote Your universal remote can operate a variety of brands of components. In order for your universal remote to control your components, you need to program the remote with the codes that match the components (See Code Lists enclosed or go to rca.com/codefinder). These codes enable the remote to communicate with your components. Each brand and each component has its own "language," and, by programming the correct codes into your remote, you tell the remote to "speak the same language" as your components.