RCA RP3710 User Guide - Page 7

Operating the Clock EN Turning off Alarm Silence the alarm momentarily Press SNOOZE. The alarm will sound again when the snooze period is over. (see "Snooze Alarm Operation"). Stop the alarm Press OFF. Then the alarm will be on the following day at the same time. Disable the alarm permanently 1. Press CANCEL button. 2. The WAKE 1 and WAKE 2 indicator will be flashing. 3. Press WAKE 1 or WAKE 2 button within 3 seconds to deactivate the alarm function permanently, "OFF" will be shown when the above procedures are done. Tip: You can activate the previously set alarm time by pressing WAKE 1 or WAKE 2 button. Snooze Alarm Operation 1. Press and hold SNOOZE. 2. Press REV or FWD to set the "quiet" period (the default time is 9 minutes) from 1 minute to 30 minutes. Release button, then the "quiet" period is set. Seconds Time Display The unit may display in seconds. 1. The clock should be in normal mode. 2. Press or to show seconds display. 3. Release to return to the hour and minute display. Brightness control You can adjust the backlight by the BRIGHTNESS button, there are three modes you may select from: OFF - Backlight always off. HIGH - Backlight always high. LOW - Backlight always low. BDrIiSghPtLneAsYs VOLUME This operation allows extra sleep time after the alarm is on. The alarm will be off by pressing SNOOZE until the snooze period is over. Snooze function can be used repeatedly up to 2 hours. After this, the alarm will yurn off until the next alarm conditions are met. Set the "quiet time" as follow: 6 RP3710 EN 7 3/3/03, 4:30 PM