RCA SPS3600 SPS3600 Product Manual - Page 2

Setting the Clock CD Playback SETTING THE CLOCK The unit must be in standby mode. To enter standby mode, make sure that the unit is plugged in, but not turned on. 1. Press the / MEMORY button until the TIME digit blinks. CD PLAYBACK 1. Press the button on the front panel or the POWER button on the remote to turn on the unit. 2. Press the CD·RADIO·AUX button to change CD mode. 2. Press the button to set the current hour. 3. Press the button to open the CD drawer. Place a CD onto the CD tray with the label side up and then press the button to close it. The CD will be scanned by the unit and the total # of tracks will be displayed. 4. Press the button to start playing the CD. The current track appears on the display. 3. Press the button to set the current minutes. Note: During playback, the track number will disappear and the time will be displayed if no button is pressed within 10 seconds. • Adjust volume by pressing the VOLUME +/- buttons. 4. Press the / MEMORY button to start the clock. The clock will automatically start if no button is pressed within 10 seconds. To Pause Playback • Press the button. The " " indicator blinks. • To resume playback, press the button again. Note:12-hour system "12:00 PM" = midnight. To Stop Playback • Press the STOP/BAND button. To SKIP to a Different Track • To SKIP to the beginning of the PREVIOUS track, or any earlier track, press the button. • To SKIP to the beginning of the NEXT track, or any later track, press the button. To FAST FORWARD or FAST REVERSE to a Particular Point • To scan forward at high speed, press and hold the button and release it at the desired point. • To scan backward at high speed, press and hold the button and release it at the desired point. • Fast forward or Fast reverse will continue searching the CD until it reaches the end. 2. Press the / buttons to select the desired track. For example, to play track 2 first, the display would look like this: 3. Press the / MEMORY button to store the track in memory. CD REPEAT PLAYBACK Repeating the Current Track • Press the REPEAT/PRESET button until "REP" appears, the current track will be played repeatedly. • Select a desired different track to be repeated by pressing the / buttons. 4. To add additional tracks, repeat steps 2 - 3 (up to 20 tracks). 5. To start playback, press the PLAY/PAUSE button. To check the program: • After setting, press the PLAY/PAUSE button to start playing, then press the / buttons to check the programmed tracks. Repeat the Entire CD • Press the REPEAT/PRESET button until "REP" blinks. All tracks will be played repeatedly. To add additional tracks during program playback: • Press the STOP/BAND button, then press the / MEMORY button repeatedly until the number of the last programmed track appears and repeat steps 2-4 above. Cancel Repeat Play • Press the REPEAT/PRESET button until "REP" disappears. CD PROGRAMMABLE PLAYBACK 20 tracks can be programmed to play in a preset order. 1. When the unit is ON and in CD MODE, make sure the CD is STOPPED. Press the / MEMORY button. "MEM" and "P 01" will blink on the display. The "P 01" is the program order (1-20). To change the programmed tracks during program playback: • Press the STOP/BAND button, and press the / MEMORY button repeatedly to select the number of the program, then press the / buttons to alter the track. Press the / MEMORY button to register the newly programmed track into memory. To erase the whole program, do one of the following: • Press the STOP/BAND button twice. • Press the CD·RADIO·AUX button to change to radio mode. • Open the CD drawer by pressing the button. Note: You can use the REPEAT function during program play. Radio Connecting with Other Optional Equipment Setting the Cooking Timer TUNING IN TO A STATION MANUALLY 1. Press the button on the front panel or the POWER button on the remote to turn on the unit. 2. Press the CD·RADIO·AUX button on the unit or the FUNCTION button on the remote control until TUNER is displayed. 3. Press the AM /FM button on the unit or the STOP/BAND button on the remote control to select AM or FM. 4. Press the / button to tune in to a desired station. Note: When using the radio, the station will disappear and the time will be displayed if no button is pressed within 10 seconds. To Quickly Search for a Station Press and hold the / button until the tuner starts searching for a station, then release. The tuner will stop on the next station. To Turn Off the Radio Press the button on the unit (or the POWER button on the remote) to turn the unit off. Setting a Radio Station PRESET The unit can store a total of 20 stations in memory (10 FM, 10 AM). Presetting allows you to tune in to a station directly. 1. Press the CD·RADIO·AUX button on the unit or the FUNCTION button on the remote control to select TUNER. 2. Press the STOP/BAND button on the remote control or the AM /FM button on the unit to select AM or FM. 3. Press the / buttons to tune in to a desired station. 4. Press the / MEMORY button until the "MEM" indicator blinks and "P 01" appears on the display. The "P 01" is the order of the preset station (1-10). 5. Press the REPEAT/PRESET button to select the preset number. 6. Press the / MEMORY button to store the station. 7. Repeat steps 3 to 6 for the next preset. TUNING IN TO A PRESET RADIO STATION 1. Press the CD·RADIO·AUX button on the unit or the FUNCTION button on the remote control until TUNER is displayed. 2. Press the STOP/BAND button on the remote control or the AM /FM button on the unit to select AM or FM. 3. Press the REPEAT/PRESET button to select a preset station. Display Function CD mode 1. During playback, press the DISPLAY button repeatedly to shuffle between the CD playback mode and the current time. 2. When stopped, press the DISPLAY button to shuffle between the total number of CD tracks and the current time. RADIO Mode • Press the DISPLAY button to shuffle between the current radio station and the current time. Listening to the Audio Signals from the External Equipment 1. Connect the AC power cord plug to the AC power outlet. 2. Pull the MP3 player docker downwards to the right place. 1. Press the TIMER button. The " " indicator appears. 3. Connect the plug of the Built-in AUX cable to the AUDIO OUT or Earphone jack of the external equipment. 2. Press the / buttons to select your desired time from 1-99 minutes. • Press the TIMER button repeatedly to select time: 10, 15, 30, 45, 60, 75, 90 minutes. • Press and hold the / buttons to fast forward/reverse the cooking time. 3. When the preset time elapses, the ALARM will sound. 4. To turn Off the ALARM, press the TIMER button once. Otherwise, the ALARM will automatically turn off after 60 minutes if no button is pressed. 4. P r e s s t h e F U N C T I O N b u t t o n o n t h e r e m o t e c o n t r o l o r t h e CD·RADIO·AUX button to change to AUX. The AUX indicator lights up. 5. Turn on your audio equipment and play the external source. Note: Do not press any buttons within 5 seconds after setting the cooking time, otherwise, the cooking timer will be cancelled. CANCELLING THE COOKING TIMER • Press the TIMER button until the time of the cooking timer shows "00". The " " indicator will disappear. Troubleshooting, Care & Maintenance REMOTE CONTROL • Is the unit plugged into a working power outlet? Try plugging it into one that you know works then test the remote control. • Is the battery weak? Replace the battery with a new one. • Make sure that you are pointing the remote control at the remote sensor on the unit. • Are you too far from the unit when using the remote control? The remote control sensor can only sense a signal from the remote control within 13 feet, so you may need to move closer to the unit. • Are there any obstacles between the remote control and the unit? If there are, remove all objects in the way. CLOCK DOES NOT SHOW CORRECT TIME: • There was a power outage. Set the clock again as described in "SETTING THE CLOCK". CLEANING THE UNIT • Do not use volatile chemicals on this unit. Clean by lightly wiping with a dry soft cloth. • Keep the CD Drawer closed to keep dust out of the unit. CLEANING THE CD • If the CD skips or will not play, the disc may need to be cleaned. Before playing, wipe the disc from the center outwards with a clean cloth. After playing, store the disc in its case. HANDLING THE CD • Only touch the CD on the edge to avoid finger prints on the underside of the CD. • Do not stick paper or tape on the underside of the CD, and do not write anything on the underside of the disc. CD LENS CARE • When your CD lens gets dirty it can cause the unit to output poor sound quality. To clean the lens you will need to purchase a CD lens cleaner. For instructions on cleaning the CD lens, refer to the instructions accompanying the CD lens cleaner. Limited Warranty AVC MULTIMEDIA ("AVC") makes the following limited warranties. These limited warranties extend to the original consumer purchaser and is limited to non-commercial user of the product. One Year Parts & Labor Warranty AVC products purchased in the United States are warranted to be free from defects in materials or workmanship for a period of one year from the date of their original retail purchase. If the unit fails to conform to this warranty, we will service the product using new or refurbished parts and products, at AVC's sole discretion. During a period of one year from the effective warranty date, AVC will provide, when needed, service labor to repair a manufacturing defect at its designated Service Center. To obtain warranty service in the United States, you must first call our Customer Support Center at 1- 877- 252 - 6873, during the hours listed in the box below. The deternination of service will be made by AVC customer support. PLEASE DO NOT RETURN YOUR UNIT TO AVC WITHOUT PRIOR AUTHORIZATION. New or remanufactured replacements for defective parts or products will be used for repairs by AVC at its designated Service Center for one year from the defective warranty date. Such replacement parts or products are warranted for an additional one year from the date of repair or replacement. The Customer will be required to ship the unit to the Service Center indicated at the time Customer Support is contacted to make the necessary repairs. The customer is responsible for all transportation charges to the service facility. Packaging and Shipping Instruction When you send the product to the AVC service facility you must use the original carton box and packing material or an equivalent as designated by AVC. LIMITED WARRANTY Your Responsibility (1) You must retain your bill of sale to provide proof of purchase. (2) These warranties are effective only if the product is purchased and operated in the U.S.A. or Canada. (3) Warranties extend only to defects in material or workmanship, and do not extend to any product or parts which have been lost or discarded, or damage to product or parts caused by misuse, accident, improper operation or maintenance, or use in violation of instructions provided with the product, or to product which has been altered or modified without authorization of AVC, or to products or parts thereof which have had the serial number removed or changed. Out of Warranty In the event your product requires repair after the limited warranty period has expired, please contact our Customer Support Center at 1-877-252-6873 or www.1800customersupport.com/RCA. Hours: Monday-Thursday: 9am-7pm, Friday: 9am-5pm, Saturday: 9am-NOON Eastern time. Important: You are responsible for any transportation, shipping or insurance relative to the return of the product to our Product Returns Center. All warranties implied by state law, including the implied warranties of merchantability and fitness for a particular purpose, are expressly limited to the duration of the limited warranties set forth above. With the exception of any warranties implied by state law as hereby limited, the foregoing warranty is exclusive and in lieu of all other warranties, guarantees, agreements and similar obligations of manufacturer or seller with respect to the repair or replacement of any parts. In no event shall AVC be liable for consequential or incidental damages. No person, agent, distributor, dealer or company is authorized to change, modify or extend the terms of these warranties in any manner whatsoever. The time within action must be commenced to enforce any obligation of AVC arising under the warranty or under any statute, or law of the United States or any state thereof, is hereby limited to one year from the date of purchase. This limitation does not apply to implied warranties arising under state law. This warranty gives you specific legal rights and you may also have other rights, which may vary from state to state. Some states do not allow limitation on how long an implied warranty lasts, when an action may be brought, or the exclusion or limitation of incidental or consequential damages, so the above provisions may not apply to you. Important: Also keep your "Bill of Sale" as proof of purchase. Model no Type of set Invoice no Dealer name Product name Serial no Date purchased FOR SERVICE AND REPAIR, PLEASE VISIT www. 1800customersupport.com/RCA Specifications and external appearance are subject to change without notice. For more information on other products and services, please contact our web site at www.1800customersupport.com/RCA. Printed in China 811-369991W010