RCA WHR120 User Guide - Page 4

WHR120_IB 10/11/00 3:58 PM Page 4 INSTALLATION 1. Connect the audio signal cable located on the back of the transmitter to the headphone jack of your audio source. This headphone jack is located on the front panel of most TVs and stereo receivers. Insert the plug on the audio signal cable into the headphone jack. Use the plug adapter included in this package if the jack is the 1/4" (6.3 mm) size. If you wish to connect directly to the "AUDIO OUT" jacks that are standard on most equipment, then you must purchase a separate adapter with the phono plugs at your local dealer. AUDIO CABLE AC SOCKET TO AUDIO SOURCES 6.3 mm STEREO ADAPTER DC ADAPTER RIGHT RECHARGE CABLE Figure 3 3.5 mm STEREO PLUG 2. Insert the connector of the AC/DC adapter into the 12V DC input connector on the rear of the IR transmitter (see figure 3 above). 3. Plug the adapter into a 120 Volt wall outlet. 4. Remove the soft earpads from the earcups by gently lifting them up. They have plastic tabs that hold them in place to the inside of the earcup. See figure 4 which illustrates the soft earpads separated from the earcup on the headset. Insert the two rechargeable batteries (AAA size) into the left and right battery compartments, ensuring that the polarity is correct (see figure 4). Replace the earpads by snapping them back in place on the earcups. The plastic tabs on the soft earpads must be matched correctly with the slots in the earcups. 5. Note: Before using the IR headphone for the first time, please ensure that batteries are fully charged (for 16 hours). This will guarantee a longer operating life for the batteries. 4