Rane CP52S CP52S Data Sheet - Page 2

CP52S COMMERCIAL PROCESSOR Parameter MIC/LINE PAGING INPUT ..........Input Type ..........RFI Filter ..........Gain range ..........Frequency Response ..........Input Referred Noise ..........CMRR ..........THD+NS ..........Phantom Power .........."Mic" Input impedance ..........Line Pad .........."Line" Input impedance ..........Signal Detector Attack ..........Signal Detector Release ..........Overload Detector ..........Low Cut / Hi Cut Filters ..........Paging Zone Level Adjust ..........Page Limiter: Threshold Range Attack Time Release Time Ratio PROGRAM INPUTS ..........Number of Inputs ..........Input Type ..........Input Level Adjust ..........Frequency Response ..........Input Impedance ..........Priority Program Input Input Detector Range Release Time Range Attack Time OUTPUTS: Type ..........Zone Out Gain: Program In From Page Inputs ..........Expand Out Gain: Zone From Page or Program In ..........Frequency Response ..........S/N ..........THD+N ..........Crosstalk ..........Output Impedance ..........Zone Maximum Output ..........Expand Maximum Output ..........Signal Present Specification Balanced Yes +30 to +60 30 to 40k -125 40 .05 +15 500 30 14.5k 10 3 +16 100 & 7k Off to 0 -20 to +20 20 250 15:1 Four Unbalanced Off to 0 10 to 50k 10k 5 to 20 50 Balanced 16 6 16 6 10 to 40k 84 .1 -75 100 20 24 -20 Data Sheet-2 Limit Units Conditions/Comments Instrumentation amplifier 2 dB Continuously adjustable typ Hz Maximum gain, +0, -3 dB 1 dBu Gain: 60 dB, Rs:150 Ω, BW: 20 kHz min dB 20 Hz to 20 kHz .01 % Gain: 30 dB, +4 dBu out, 1 kHz, BW: 80 kHz 4% VDC 1% Ω Each leg to ground 1 dB Defeats phantom power 1% Ω Each leg to ground typ msec Fixed; 10 dB overdrive typ sec Fixed 1 dBu 4 dB before clipping 5 Hz Selectable In/Out dB typ dBu Continuously adjustable typ msec For a 10 dB step; fixed typ msec For a 10 dB step; fixed typ Soft knee All controls duplicated for each input Stereo RCA connector dB typ Hz +0, -3 dB 20 Ω typ dBu On rear panel; factory set to -50 dBu typ sec On rear panel; factory set to 15 seconds typ msec For a 20 dB step; fixed Euroblock connector 1 dB 100 kΩ load 1 dB 1 dB 100 kΩ load 1 dB typ Hz +0, -3 dB min dBr re +4 dBu; BW: 20 Hz-20 kHz max % +4 dBu, 1 kHz, BW: 80 kHz max dB 1 kHz, Rs: 25 Ω, (L/R) 1% Ω Each leg typ dBu RL: 600Ω typ dBu RL: 2 kΩ typ dBu Maximum