Rane DA 26S DA 26S Data Sheet - Page 4

DA 26S DISTRIBUTION AMPLIFIER WITH PAGING Rear Panel Arhchitectural Specifications The DA 26S shall provide a balanced, line-level, music input with automatic gain control featuring adjustable target level, ratio and response time. A seven-segment meter shall indicate the amount of gain modification over a range of -12 dB to +12 dB. A 4th-order Linkwitz-Riley crossover shall provide three music signal outputs: full-range, high-pass and low-pass. The crossover shall have the ability to select any of four crossover points: 80, 110, 150 or 200 Hz. The unit shall have six balanced outputs. Each output shall have the ability to select the full-range, high-pass or low-pass crossover signal as its source. A means to adjust each output level over a range of ±12 dB shall be provided on the front panel. The unit shall provide a remote level control port for each of the six outputs. The range of control shall be 0 to -80 dB. The remote port topology shall allow ganging any number of ports to a single remote device. Remote level control of low-pass outputs shall include Loudness compensation. Priority/Page input shall be provided. This input shall accommodate microphone or line-level signals. Line-level gain shall have a range of 0 dB to 30 dB. Microphone gain shall have a range of 30 dB to 60 dB. Automatic threshold detection shall have a sensitivity adjustment range of +4 dBu to ON. A priority assign port shall provide a means of routing the priority input to any combination of zone outputs. When the Page/Priority signal exceeds the set threshold, an "active" indicator lights, the input signal routes to selected zone(s) and the music ducking circuit is enabled for selected zone(s). Automatic music attenuation shall be adjustable from 0 to -80 dB. Front panel and remote output level controls shall not influence the Priority/Page signal. The unit shall mount in a standard 19-inch rack and occupy 1U. The unit shall accommodate an optional SC 1.7 single space security cover. All input and output connections shall be made via European-style terminal blocks. The unit shall be capable of operation by means of its own built-in universal power supply operating at 100-240 VAC and meet CE requirements. The unit shall be UL and cUL listed. The unit shall be entirely constructed from cold-rolled steel. The unit shall be a Rane DA 26S Distribution Amplifier. Available Accessories • VR1 Remote Control GND Vc • SC 1.7 Single Space Security Cover Vr LEVEL 46 2 8 0 10 Use up to 6 optional VR1 Remotes, one for each output. ©Rane Corporation 10802 47th Ave. W., Mukilteo WA 98275-5000 TEL 425-355-6000 FAX 425-347-7757 WEB rane.com Data Sheet-4 All features & specifications subject to change without notice. 1-2014