Rane DA 26S DA 26S Manual - Page 6

Rear Panel Description DA 26S 100-240 V 50/60 Hz 7 WATTS COMMERCIAL AUDIO EQUIPMENT 24TJ R 6 RMT OUT Vr Vc +− MADE IN U.S.A. RANE CORP. ACN 001 345 482 Vr Vc +− 5 RMT OUT Vr Vc +− Vr Vc +− 4 RMT OUT Vr Vc +− Vr Vc +− 3 RMT OUT Vr Vc +− Vr Vc +− 2 RMT OUT Vr Vc +− Vr Vc +− 1 RMT OUT Vr Vc +− Vr Vc +− LINE INPUT +− PRIORITY ASSIGN Z1 Z2 Z3 Z4 Z5 Z6 ALL PRIORITY INPUT LINE + − +− Z1 Z2 Z3 Z4 Z5 Z6 ALL MIC +− 1 PRIORITY INPUT connector and MIC/LINE switch: The balanced PRIORITY INPUT operates at line or mic level, determined by the MIC / LINE switch. This Input accepts unbalanced signals, however, we do not recommend unbalanced operation unless the source is within 3 feet [one meter]; then only connect (+) and (GND). Note: the Priority Input is not influenced by the AGC, Crossover, Output trims or Remote Level controls. The gain range for MIC level Input is 30 to 60 dB. The gain range for LINE level Input is 0 to 30 dB. 2 PRIORITY ASSIGN port: The state of the PRIORITY ASSIGN port determines Priority Input assignment to each of the six Outputs. Assignment pins are active low with passive internal pull-up. Any combination of pins may be active at one time. The select ALL pin is provided for convenience. To complete an assignment, the Output must be selected by the PRIORITY ASSIGN port and Priority Detect must be active. Note that if a combination of Crossover Outputs is used in one zone, all Outputs serving the zone must be selected by the PRIORITY ASSIGN port. Variations in wire type do not greatly affect the performance of this port. However, 22-gauge stranded wire with a flexible jacket is recommended. Unshielded multi-conductor cable is OK for shorter runs (less than 100 feet). For longer runs, we recommend shielded cable. 3 LINE INPUT connector: Connect a balanced line level source to the Line Input. The Line Input accepts an unbalanced Input connected to (+) and (GND), but we do not recommend unbalanced connection unless the distance to the source is less than one meter; then only connect (+) and (GND). 4 OUTPUT and REMOTE connectors: are on single 6-pin Euroblocks, one set for each Output. Outputs are line-level, balanced, and hopefully driving a balanced equalizer or amplifier. If not, keep cable lengths short and consult the RaneNote, "Sound System Interconnection" located elsewhere in this manual. Connections for optional wired Remote Level controls are provided for each Output. Note: Remote Level controls do not affect the level of the Priority Input. Each port provides a 5 volt reference voltage (REF), a control voltage input (Vc) and a ground reference. Gain control law is 50 mV/dB. See Setup and Operation, step 6 for details. 5 Universal Voltage Input: via a miniature IEC 60320 C6 appliance inlet. With the right cord, you can plug anywhere in the world between 100 and 240 VAC. This mates with an IEC 60320 C5 line cord (USA domestic). Do not lift the ground connection! Manual-3