Rane ME15S Operation Manual - Page 5

Front Panel Description CHANNEL 1 4 6 2 8 0 10 OL LEVEL BYPASS ±12 ±6 RANGE 25 40 63 100 160 250 400 630 1k 1.6k 2.5k 4k 6.3k 10k 16k + + 6 12 • • 3 6 • • 0 0 • • 3 6 • • 6 12 CHANNEL 2 4 6 2 8 0 10 OL LEVEL BYPASS ±12 ±6 RANGE 25 40 63 100 160 250 400 630 1k 1.6k 2.5k 4k 6.3k 10k 16k + + 6 12 • • 3 6 • • 0 0 • • 3 6 • • 6 12 ME15S MICROGRAPHIC EQUALIZER POWER 43 2 1 43 2 1 5 1 Filter level slide controls: Each of these sliders controls the output level of each of the bandpass filters. Center position is detented and grounded for guaranteed flat response. 2 Filter RANGE switches: The gain range of the filter sliders is switchable (as a group) from ±6 dB for high resolution, to ±12 dB for maximum boost/cut capability. 3 BYPASS switches: When the button is pushed and the red indicator is lit, this Channel is in the BYPASS mode: signal is routed directly from the Input to the Output without passing through any active circuitry (often referred to as "hard‑wire bypass"). Use this switch to compare equalized and unequalized material, or to bypass the equalizer in the event of power loss or unit failure. 4 LEVEL controls and OL indicators: These control the level of signal coming into the ME15S. Turn this control down if it's OL (OverLoad) lights up steadily (meaning too strong an Input signal). Since actual unity gain depends on varying slider settings (which is why we have not marked a unity gain position on the front panel), use the BYPASS switch to determine the exact unity gain position of this LEVEL control by comparing EQ and BYPASS volumes. The OL indicator lights up if any section of the ME15S is within 3 dB of clipping. Occasional blinking of these LEDs are acceptable, but if they remain on more than intermittently, turn down either the equalizer's LEVEL control(s) or reduce the output level of the preceding component to avoid distortion. 5 POWER: As you have astutely surmised by now, when the ME15S is plugged into 85-240 VAC, this glows yellow. Manual-2