Rane Sixty-Eight Sixty-Eight Mixer Manual for Serato DJ - Page 33

OWNER'S MANUAL Fader Assembly Removal 1 Remove all five fader knobs. 2 Remove all four screws holding the fader panel face plate. 3 Lift up the fader panel face plate and set it aside where it can't get damaged. 4 Remove the two screws in the main panel at the top of the fader assembly. 5 Remove the two screws at the front of the fader assembly. 6 Slide the fader assembly out just enough to see the three white and blue wires and their connectors. 7 Unplug the connectors of the three white and blue wires. 4 8 Slide out the fader assembly completely. 9 The channel faders are mounted in pairs. Remove the four screws for each pair of faders (1 and 2) or (3 and 4). 0 The magnetic crossfader may be removed by the two screws at each end of the crossfader. Reverse this procedure to re-assemble. • Plug in all three cables before installing screws. • Confirm cables are not crossed, with 7 faders 1 & 2 on the left connector, faders 3 & 4 on the right connector, and the blue crossfader wires in the center. • Test all the faders before installing the fader panel face plate and fader knobs. 1 2 3 68 5 9 0 SIXTY-EIGHT 33