Rane VR2 VR2 Remote Data Sheet / Manual - Page 2

Wire Types Variations in wire type do not greatly affect the performance of the remote controls. However, a minimum gauge of 22 stranded wire with a flexible jacket is recommended. You may use 3-conductor unshielded remote control signal cable for shorter runs (less than 200 ft.) or 2-conductor (1 pair) shielded remote control signal cable (use the shield as the GND return) for longer runs (200 to 1000 ft.). The type of wire required is influenced by your installation and local electrical codes. Rane Corporation does not provide or source cable. Please contact your local retail or wholesale outlet, not the factory. The following is a short list of suitable cable types: CONSOLIDATED ELECTRONIC WIRE AND CABLE Plenum cable: Unshielded remote control signal cable CAT. # 9896 Shielded remote control signal cable CAT. #9877, CAT. #9852 WEICO WIRE & CABLE INC. Communication and control cable: Multiconductor, unshielded CAT. #7606 ALPHA Communication and control cable: Multiconductor, unshielded CAT. #1175C BELDEN Unshielded remote control signal cable CAT. # 88741 Shielded remote control signal cable CAT. # 88723 CW GND Vc 20 kΩ, linear taper Vr VR2 All-in-One Block Diagram and Schematic VERSATILE INPUT PORT 0-5V +5v / 100 mA 1 2 3 4 5 6 7 8 REF GND 1 2 3 4 5 6 7 8 REF GND GND Vc Vr Wiring shown for VR2 to control VIP pin 1 on RPM series units. Versatile Input Port REF GND VIP pin 1....8 Silkscreen text on VR2 Vr GND Vc WARNING: This product may contain chemicals known to the State of California to cause cancer, or birth defects or other reproductive harm. ©Rane Corporation 10802 47th Ave. W., Mukilteo WA 98275-5000 TEL 425-355-6000 FAX 425-347-7757 WEB rane.com All features & specifications subject to change without notice. PN 12907