RedMax BT280 Owners Manual - Page 6
Muffler, Cutting equipment, Trimmer head
View all RedMax BT280 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
SAFETY INSTRUCTIONS Muffler S Never use a machine that has a faulty muffler. WARNING: Never use a machine with faulty safety equipment. The machine's safety equipment must be checked and maintained as described in this section. If your machine fails any of these checks contact your servicing dealer to get it repaired. Use of a machine with faulty safety equipment increases the risk of serious personal injury to the operator or others. S Regularly check that the muffler is securely attached to the machine. S The muffler on this unit is equipped with a special spark arrestor mesh. The mesh should be checked and, if necessary. cleaned by a servicing dealer. A blocked mesh will cause the machine to overheat, which can lead to serious damage. Never use a muffler with a defective spark arrestor mesh. See the Maintenance section. Cutting equipment This section describes how to choose and maintain your cutting equipment in order to: S Obtain maximum cutting performance. S Extend the life of cutting equipment. General rules: 1. Only use cutting attachments with the guards we recommend! See the section on "Technical Data". 2. Check the cutting attachment for damage or cracks. A damaged cutting attachment should always be replaced. IMPORTANT! This section describes how to choose and maintain your cutting equipment in order to: Obtain maximum cutting performance. Extend the life of cutting equipment. Only use cutting attachments with the guards we recommend! See the section on "Technical data". Refer to the instructions for the cutting attachment to check the correct way to load the trimmer line and the correct line diameter. Trimmer head S Only use the recommended cutting at- tachments. See the section on "Technical data". S Smaller machines generally require small trimmer heads and vice versa. This is because when clearing using trimmer line the engine must throw out the trimmer line radially from the trimmer head and overcome the resistance of the grass being cleared. S The length of the trimmer line is also important. A longer trimmer line requires greater engine power than a shorter trimmer line of the same diameter. S Make sure that the cutter on the trimmer guard is intact. This is used to cut the trimmer line to the correct length. S To increase the life of the trimmer line it can be soaked in water for a couple of days. This will make the line tougher so that it lasts longer. IMPORTANT! Always ensure the trimmer line is wound tightly and evenly around the drum, otherwise the machine will generate harmful vibration. WARNING: Always stop the en- gine before doing any work on the cutting attachment. This continues to rotate even after the throttle has been released. Ensure that the cutting attachment has stopped completely and disconnect the lead from the spark plug before you start to work on it. 115391427 Rev. 4 5/15/12 English--- 6