RedMax EXZ2460S-PH Owners Manual - Page 13
Safety Lock Ma8, Anti-vibration System
View all RedMax EXZ2460S-PH manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
8. Maintenance MA5 IMPORTANT • If waste gets stuck and causes blockage around the intake air cooling vent or between the cylinder fins, it may cause the engine to overheat, and that in turn may cause mechanical failure on the part of the hedge-trimmer. ■ BLADES Oil blades each gas tank filling (MA5). WARNING • Make sure that the blade bolts are well tightened. • The blade assembly is designed to automatically compensate for any play between the blades. MA8 Check the cutting edges and reform with a flat file. (MA6) MA6 Point : 1. Keep the end corner sharp. 2. Round the root of the edge. 3. Do not use water when using a grinder. IMPORTANT • When mounting the blade, make sure to fasten the spacer, washer and bolt, then fasten the nut. (1) Bolt (2) Plate (3) Spacer (4) Nut MA9 MA7 ■ SHARPENING (MA7) Always keep the file or sharpener at an angle of 45° to the blade, and: • Always grind in the direction of the cutting edge; • Note: files cut only in one direction; lift the file from the blade when returning to start a new pass; • Remove all burr from the edge of the blade with a slip stone; • Remove as little material as possible; • Before refitting the sharpened blades, remove filings and then apply grease. Do not try to sharpen a damaged blade: change it or take it to a Service dealer. MA10 HTZ2460/HTZ2460L/CHTZ2460/CHTZ2460L ■ SAFETY LOCK (MA8) WARNING • Stop operation when the safety lock is defective. U S • Safety lock is the device not to accelerate the throttle lever without intention. While pushing the safety lock, you can accelerate the throttle lever. 1. Check if the throttle lever does not move when you do not push the safety lock. 2. Check if the throttle lever moves when you grasp or release it while pushing the safety lock. 3. Check if the safety lock returns to its original position when you release your hand from safety lock. • If you find any defects at the checks above, contact your nearest servicing dealer for repair. (1) Safety lock ■ REDUCTION GEARBOX Refill gear housing every 50 working hours (MA9). Use greese pump. Feed greese until it comes out of the base of blades. Grease nipple: A type ■ ANTI-VIBRATION SYSTEM WARNING • The deformed or damaged antivibration system may cause of the breakages like getting rickety or falling off of engine and/or blade. • [HTZ2460/HTZ2460L] Check periodically if the rubber cushions are not deformed or damaged. • [CHTZ2460/CHTZ2460L] Check periodically if the springs are not deformed or damaged. US-13