Reebok 1410 Treadmill English Manual - Page 32
Troubleshooting
View all Reebok 1410 Treadmill manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 32 highlights
TROUBLESHOOTING Most treadmill problems can be solved by following the simple steps below. Find the symptom that applies, and follow the steps listed. If further assistance is needed, see the front cover of this manual. SYMPTOM: The power does not turn on a. Make sure that the power cord is plugged into a surge suppressor, and that the surge suppressor is plugged into a properly grounded outlet (see page 18). Use only a surge suppressor that meets all of the specications described on page 18. IMPORTANT: The treadmill is not compatible with GFCI-equipped outlets and may not be compatible with AFCI-equipped outlets. b. After the power cord has been plugged in, make sure that the key is inserted into the console. c. Check the power switch located on the treadmill frame near the power cord. If the switch protrudes as shown, the switch has tripped. To reset the power switch, wait for ve minutes and then press the switch back in. SYMPTOM: The console displays remain lit when you remove the key from the console a. The console features a display demo mode, designed to be used if the treadmill is displayed in a store. If the screen shows a preset presentation when you remove the key, the demo mode is turned on. To turn off the demo mode, hold down the Stop button for a few seconds. If the demo mode is still on, see step 7 on page 27 to turn off the demo mode. SYMPTOM: The incline of the treadmill does not change correctly a. Calibrate the incline system (see step 4 on page 29). SYMPTOM: The iFit mode does not function correctly a. If the iFit mode is not functioning correctly, make sure that the treadmill has the most current firmware available (see step 3 on page 29). c Tripped Reset SYMPTOM: The treadmill will not connect to a wireless network a. Make sure that the wireless settings on your console are correct (see step 4 on page 30). SYMPTOM: The power turns off during use a. Check the power switch (see the drawing above). If the switch has tripped, wait for ve minutes and then press the switch back in. b. Make sure that the power cord is plugged in. If the power cord is plugged in, unplug it, wait for ve minutes, and then plug it back in. b. Make sure that the settings for your wireless network are correct. c. If your wireless network is set to use WEP encryption, try setting it to WPA or WPA2 encryption instead. d. If you still have questions, see the front cover of this manual. c. Remove the key from the console, and then reinsert it. d. If the treadmill still will not run, please see the front cover of this manual. 32