Reebok 8000 Es Treadmill English Manual - Page 9

5. With the help of a second person, carefully tip the treadmill onto its right side. Partially fold the Frame (48) so the treadmill is more stable; do not fully fold the Frame yet. Remove and discard the two indicated bolts (A) and the shipping bracket (B). Attach a Base Pad (81) to the Base (85) in the location shown with an M4.2 x 25mm Tek Screw (2) and a Base Pad Spacer (104). Then, attach a Base Pad (81) in the location shown with only an M4.2 x 25mm Tek Screw (2). Remove the M10 Nut (33), the M10 x 50mm Bolt (4), and the shipping bracket (C) from the Base (85). Attach a Wheel (86) with the Bolt and the Nut that you just removed. Do not overtighten the Nut; the Wheel must turn freely. Discard the shipping bracket. 5 A 2 81 85 B 48 4 104 86 2 81 C 33 6. Press a Base Endcap (82) into the Base (85). With the help of a second person, hold a Bolt Spacer (79) inside the lower end of the Left Upright (73). Insert an M10 x 96mm Bolt (5) with an M10 Star Washer (8) into the Left Upright and the Bolt Spacer. Repeat this step with a second Bolt Spacer (79), M10 x 96mm Bolt (5), and M10 Star Washer (8). Orient the Left Upright (73) and the Left Upright Spacer (83) as shown. Hold the Left Upright Spacer and the Left Upright against the Base (85). Tighten the M10 x 96mm Bolts (5) until the heads of the Bolts touch the Left Upright; do not fully tighten the Bolts yet. With the help of a second person, tip the treadmill so that the Base (85) is flat on the floor. 7. Set the Console (87) face down on a soft surface to avoid scratching the Console. Remove the six M4.2 x 19mm Screws (1). Lift off the Pulse Support (109). Save the Pulse Support and all six M4.2 x 19mm Screws (1) for step 9. 6 5 8 82 79 85 73 83 7 1 1 109 1 87 9