Reebok Rl 645 Elliptical English Manual - Page 7

5. Hold a Ramp Wheel (50) inside of the bracket on one of the Chrome Tubes (45). Hold the Chrome Tube and the Ramp Wheel inside of the bracket on the Left Pedal Leg (46). Slide a Wheel Cover (51) onto the long part of a Bolt Set (101), and insert the Bolt Set into the Left Pedal Leg, the Chrome Tube, and the Ramp Wheel. Slide a Wheel Cover (51) onto the short part of the Bolt Set (101). Then, tighten the short part of the Bolt Set into the long part. Attach the other Chrome Tube (not shown) and the other Ramp Wheel (not shown) to the right side of the elliptical exerciser in the same way. 5 45 50 101 51 101 46 51 6. Identify the Left Pedal (48), which is marked with an "L." Attach the Left Pedal to the Left Pedal Leg (46) 6 with two M8 x 52mm Button Bolts (100), two M8 Split Washers (122), and two M8 Washers (132). Attach the Right Pedal (not shown) to the Right 48 Pedal Leg (not shown) in the same way. 7. Have another person hold the Upright (2) in the position shown. Make sure that the Upright is turned so that the three holes are aligned with the holes in the Frame (1). Connect the Upper Wire Harness (18) to the Lower Wire Harness (53). Carefully pull the upper end of the Upper Wire Harness to remove the slack from the Wire Harnesses. Slide the Upright (2) onto the Frame (1). Be careful to avoid pinching the Wire Harnesses. Attach the Upright to the Frame with three M10 x 25mm Button Screws (123) and three M10 Split Washers (118). 46 132 132 122 122 100 7 2 118 123 118 123 118 18 53 1 7