Reebok Rl 900 Elliptical Exerciser English Manual - Page 6
Pedal Arm Wheel not shown to the Right Pedal
View all Reebok Rl 900 Elliptical Exerciser manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
5. Attach a Pedal Assembly (39) to the Left Pedal Arm (9) with five M4 x 16mm Screws (89). 5 39 Attach the other Pedal Assembly (not shown) to the Right Pedal Arm (not shown) in the same way. 9 89 89 6. Remove the two Pivot Shafts (10) from the two Pivot Arms (not shown). Next, identify a Union Set (86), and remove the screw from the barrel. Apply a small amount of grease to the outside of the barrel. Slide an M8 x 18mm Washer (93), a Wheel Cap (53), and a 30mm Spacer (87) onto the barrel of the Union Set (86). While another person aligns the indicated holes in the Left Pedal Assembly (39), a Pedal Arm Wheel (52), and a Pivot Shaft (10), insert the barrel through all of the holes. Then, slide another 30mm Spacer (87) onto the barrel. Next, slide an M8 x 18mm Washer (93) and a Wheel Cap (53) onto the screw of the Union Set (86), and tighten the screw into the barrel. Attach the other Pivot Shaft (not shown) and the other Pedal Arm Wheel (not shown) to the Right Pedal Assembly (not shown) in the same way. 7. While another person holds the Upright (4) near the Frame (1), connect the Upper Wire Harness (58) to the Extension Wire Harness (59). Slide the Upright onto the top of the Frame, being careful not to pinch the Wire Harnesses. Attach the Upright (4) to the Frame (1) with two M8 x 47mm Button Screws (110), an M8 x 25mm Button Screw (100), and three M8 Split Washers (85). 6 10 87 93 86 53 Grease Align these holes 93 86 87 53 52 39 7 Do not pinch the wire harnesses during this step. 4 85 110 85 100 58 1 59 6