Reebok Rl525 Elliptical English Manual - Page 9

11. Position a Pedal Cushion (74) on the Left Pedal Leg 11 (28) so that the arrow is pointing to one of the num- bers on the Left Pedal Leg. Set the Left Pedal Arm (33) on the Pedal Cushion, with the end of the Left Pedal Arm inside of the bracket on the Left Pedal Leg. Hold a Plastic Pedal Arm Spacer (65) between the Left Pedal Leg (28) and the Left Pedal Arm (33). Insert the long part of a Bolt Set (67) through the Left Pedal Leg, the Plastic Pedal Arm Spacer, and the Left Pedal Arm. Lift the Left Pedal Leg (28), and hold the Left Upper Body Arm (5) inside of the bracket on the Left Pedal Arm (33). Insert the long part of the Bolt Set (67) through the Left Upper Body Arm. Hold another Plastic Pedal Arm Spacer (65) between the Left Pedal Arm and the Left Pedal Leg, and insert the long part of the Bolt Set through these parts. Tighten the short part of the Bolt Set into the long part. Attach the other Pedal Cushion (not shown) and the Right Pedal Arm (32) in the same way. 5 65 32 33 65 67 67 28 Arrow 74 12. Make sure that all parts are properly tightened before you use the elliptical exerciser. Note: Some hardware may be left over after assembly is completed. HOW TO INSTALL THE RECEIVER FOR THE OPTIONAL CHEST PULSE SENSOR The elliptical exerciser is now fully assembled. If you purchase the optional chest pulse sensor (see page 21), follow the steps below to install the receiver included with the chest pulse sensor. 1. Refer to assembly step 6 on page 7, and remove the two M4 x 25mm Screws (not shown) and the Bookrack 1 7 (7). 8 Next, look under the Console (8) and locate the three indicated screws (not shown). Remove the three screws. Do not remove the screws attaching the Console to the Console Bracket (not shown). 2. Carefully lift the top of the Console (8) as shown. Using the two small screws included with the chest pulse sensor, attach the receiver to the indicated plastic posts on the Console. Make sure that the receiver is turned exactly as shown. Connect the wire on the receiver to the indicated wire on the Console. Refer to step 1 above. Lower the top of the Console (8). Make sure that no wires are pinched. Reattach the top of the Console with the three screws removed in step 1. Refer to assembly step 6 on page 7, and reattach the Bookrack (7) with the two M4 x 25mm Screws (not shown). Note: The remaining wires included with the chest pulse sensor may be discarded. 9 Screws 2 Screws 8 Wire Receiver Posts