Reebok Trainer Rx 2.0 Gw Bike English Manual - Page 5

ASSEMBLY To hire an authorized service technician to assemble the exercise bike, call 1-800-445-2480. Assembly requires two persons. Place all parts of the exercise bike in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed. In addition to the included tool(s), assembly requires a Phillips screwdriver wrench , and a rubber mallet . , an adjustable See the drawings below to identify the small parts needed for assembly. The number in parentheses below each drawing is the key number of the part, from the PART LIST near the end of this manual. The number following the key number is the quantity needed for assembly. Note: If a part is not in the hardware kit, check to see if it has been preassembled. To avoid damaging parts, do not use power tools for assembly. M8 Locknut (72)-4 M8 Split Washer (75)-8 M8 Washer (43)-2 M4 x 5mm Bright Screw (91)-1 M4 x 16mm Screw (90)-8 M8 x 20mm Patch Screw (74)-4 M10 x 95mm Patch Screw (76)-4 M6 x 70mm Bolt Set (50)-1 M6 x 60mm Bolt Set (51)-1 1. To make assembly easier, read the 1 information above before you begin. Attach the Rear Stabilizer (3) to the Frame (1) with two M10 x 95mm Patch Screws (76). 3 1 76 5