Rheem Professional Powered Damper Series Brochure - Page 2

Superior Construction and Reliability

Page 2 highlights

Superior Construction and Reliability • Hot Water Outlet: The connection point for the hot water service piping, which ­carries the hot water to faucets and other hot water fixtures or appliances. • T emperature and Pressure Relief Valve (T&P valve): this ­safety device opens to a­ llow water to escape from the water heater in the unlikely event that either the tank pressure or temperature become excessive. • Rigid Foam Insulation: A thick layer of rigid polyurethane foam insulation helps ­minimize heat loss. • Anode Rod: The patented R-Tech anode rod, a replaceable c­ omponent made of magnesium, p­ rotects tank against ­premature corrosion. • Flue: The flue is a steel tube passing through the center of the water heater tank which carries combustion gasses to the water heater venting system. • EverKleen™ Self Cleaning System: The patented EverKleen System creates a ­turbulent swirling action as water enters the tank. It fights s­ ediment build-up and helps improve operating e­ fficiency. • Brass Drain Valve: Allows tank to be ­emptied should service be required. • Gas Control Valve: Also referred to as the thermostat, this device takes the unregulated main supply gas and regulates the gas for use by the water heater. • Draft Hood: This capping device, which connects to the venting system, assists in the upward movement of combustion gases. • Heat Trap Nipples: They create a gap ­preventing conductive heat loss to the hot and cold service pipes. • Cold Water Inlet and Dip Tube: The connection point for incoming cold water. The inlet connects directly to a dip tube which directs the water to the bottom of the tank. • Exclusive Rheemglas® Porcelain Enamel Tank Lining: Engineered for durability and long tank life. • Flue Baffle: The flue baffle slows the upward motion of combustion gases to maximize dispersion of heat into the tank. • Thermocouple: Detects pilot operation. Shuts down burner valve should pilot light go out, thus preventing gas emissions when there is no source of ignition. • Burner Pilot: Operates continuously to ignite main burner when the thermostat calls for heat. • Gas Burner: Heats water from below the ­storage tank. • Guardian System™: Automatically shuts down the water heater if flammable vapors are detected. Maintenance-free ­protection. No filters to clean. Standard ­replacement parts. Available on most models. Spark Ignition Flexible Burner Supply Tube Sight Glass Sealed Inner Door The Guardian System™ from Rheem Damper Pan Air Shut-off Plate Corrosion Resistant Bottom Shut-off Spring Air Intake System Arrestor Plate Shield Thermal Safety Device Flame Arrestor Plate WINaTteErGR| RATeEsDidHeOnMtEiaCl OGMaFsOWRTater Heaters

  • 1
  • 2
  • 3
  • 4

Hot Water Outlet:
The connection point
for the hot water service piping, which
carries the hot water to faucets and other
hot water fixtures or appliances.
Temperature and Pressure Relief Valve
(T&P valve):
this safety device opens
to allow water to escape from the water
heater in the unlikely event that either the
tank pressure or temperature become
excessive.
Rigid Foam Insulation:
A thick layer of
rigid polyurethane foam insulation helps
minimize heat loss.
Anode Rod:
The patented R-Tech anode
rod, a replaceable component made
of magnesium, protects tank against
premature corrosion.
Flue:
The flue is a steel tube passing
through the center of the water heater tank
which carries combustion gasses to the
water heater venting system.
EverKleen
Self Cleaning System:
The patented EverKleen System creates
a turbulent swirling action as water enters
the tank. It fights sediment build-up and
helps improve operating efficiency.
Brass Drain Valve:
Allows tank to be
emptied should service be required.
Gas Control Valve:
Also referred to
as the thermostat, this device takes
the unregulated main supply gas and
regulates the gas for use by the
water heater.
Draft Hood:
This capping device, which
connects to the venting system, assists
in the upward movement of combustion
gases.
Heat Trap Nipples:
They create a gap
preventing conductive heat loss to the hot
and cold service pipes.
Cold Water Inlet and Dip Tube:
The con-
nection point for incoming cold water. The
inlet connects directly to a dip tube which
directs the water to the bottom of the tank.
Exclusive Rheemglas
®
Porcelain Enamel
Tank Lining:
Engineered for durability and
long tank life.
Flue Baffle:
The flue baffle slows the
upward motion of combustion gases to
maximize dispersion of heat into the tank.
Thermocouple:
Detects pilot operation.
Shuts down burner valve should pilot light
go out, thus preventing gas emissions
when there is no source of ignition.
Burner Pilot:
Operates continuously to
ignite main burner when the thermostat
calls for heat.
Gas Burner:
Heats water from below the
storage tank.
Guardian System
: Automatically shuts
down the water heater if flammable vapors
are detected. Maintenance-free protection.
No filters to clean. Standard replacement
parts. Available on most models.
Water | Residential Gas Water Heaters
Superior Construction and Reliability
Spark
Ignition
Air
Intake
System
Sight
Glass
Thermal
Safety
Device
Sealed
Inner Door
Damper
Pan
Air
Shut-off
Plate
Corrosion
Resistant
Bottom
Shut-off
Spring
Flame
Arrestor
Plate
Flexible
Burner
Supply
Tube
Arrestor
Plate
Shield
The Guardian System
from Rheem