Ricoh 2020D Operating Instructions - Page 103
Preparing to Use the Network TWAIN Scanner, System Settings, Effective Protocol, TCP/IP
View all Ricoh 2020D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 103 highlights
Before Using the Network TWAIN Scanner Preparing to Use the Network TWAIN Scanner This section describes the preparations and settings for using the machine as a network TWAIN scanner. Important ❒ To use the network TWAIN scanner, an application that supports the scanner, such as DeskTopBinder Lite, must be installed on the computer. DeskTopBinder Lite is on the supplied CD-ROM. For details about installing DeskTopBinder Lite, see "Installing DeskTopBinder Lite from the Supplied CD-ROM". A Connect the machine to the network. Connect the machine to the network using an Ethernet cable or wireless LAN (IEEE 802.11b). B Make the necessary network settings in [System Settings]. If you have connected the machine to the network using an Ethernet cable, 5 make the following settings. For details, see General Settings Guide. • Specify the machine's IP address and subnet mask • In [Effective Protocol], enable [TCP/IP] C Install the TWAIN driver on a client computer. For details about installing the TWAIN driver, see "Installing the TWAIN Driver from the Supplied CD-ROM". Note ❒ To connect the machine to the network using a wireless LAN (IEEE 802.11b), an extended wireless LAN board is required respectively. For details, see Network Guide. ❒ For details about [System Settings], see General Settings Guide. ❒ Items to set up in [System Settings] vary depending on the network environment. For details about the network settings, see General Settings Guide. Reference p.96 "Installing the TWAIN Driver from the Supplied CD-ROM" p.79 "Installing DeskTopBinder Lite from the Supplied CD-ROM" 95