Ricoh PJ WU5570 Users Manual - Page 83
Replacing the lamp
View all Ricoh PJ WU5570 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 83 highlights
Replacing the lamp The projector will detect the lamp life itself. It will show you a warning message Warning! Lamp Lamp is approaching the end of its useful life. Replacement Suggested! When you see this message, change the lamp as soon as Warning: To avoid burns, allow the possible. Make sure the projector has been cooled down for at least 60 minutes before changing the lamp. projector to cool for at least 60 minutes 2 before you replace the lamp! 1 3 4 Warning: Do not drop the lamp module or touch the glass parts. 5 The glass parts may shatter and cause injury if it is dropped. Warning: For continued safety replace with Replacement Lamp Type 22. Lamp Replacing Procedure: Caution: If the lamp should break, handle with care to avoid injury due to broken pieces and contact your sales representative for repair service. 1. Switch off the power to the projector by pressing the " " button. 2. Allow the projector to cool down at least 60 minutes. 3. Disconnect the power cord. 4. Remove the screw on the lamp cover. 5. Slide the lamp cover to the side and remove the cover. 6. Remove the 2 screws on the lamp module. 7. Lift up the lamp handle. 8. Carefully remove the lamp module. 9. Install the new lamp module by reversing the previous steps. See the lamp's manual for instructions on resetting the lamp time. Used Lamps This projector's lamp contains trace amounts of environmentally harmful inorganic mercury. Be careful not to break used lamps, and dispose of them in accordance with local regulations or contact your sales representative. 81 English English