Ricoh Pro 8100 EX User Guide - Page 1100

Finisher SR5050/SR5060 2. Print the image. Is the problem resolved? Yes Finished! No Go to the next step. 3. In the [Machine: Paper Feed/ Output] group on the [Adjustment Settings for Skilled Operators] menu, set [Adjust Paper Curl] to "Adjust Curl". Select "Strong" or "Weak" to control the level of decurling as required. 4. Print the image. Is the problem resolved? Yes Finished! No Contact your service representative. • For details about attaching the Z-fold support tray for multi-folding unit, see "Copy/ Document Server" supplied with the machine. • If the Z-fold support tray for multi-folding unit is attached, the trailing edge of the ejected sheets will not be too close to the paper exit, so no problem will occur. However, the stapled sheets may not be stacked properly. Sheets cannot be stapled properly Cause: When the sheets are fed to the staple unit inside the finisher, they may be overlaid, resulting in a misalignment of 5 mm (0.2 inches) relative to each other after stapling. When coated or other paper producing higher paper-to-paper friction is used, the paper edges are not aligned properly, resulting in misaligned stapling. This is likely to occur if: • Coated or other paper producing higher paper-to-paper friction is used. • Thin or other limp paper is used. Solution: Reduce the number of sheets to be stapled. 1. In the [Finishing: Finisher] group on the [Adjustment Settings for Skilled Operators] menu, select [Number of Sheet Align for Stapling], and reduce the number of sheets to be stapled. 109