Rocketfish RF-G1502 Quick Setup Guide (English) - Page 1

QUICK SETUP GUIDE RF-TVMLPT01 Thank you for choosing the Rocketfish RF-TVMLPT01. The RF-TVMLPT01 TV mount is designed to support a TV weighing up to 50 lbs. (22.7 kg). 1 Install locking screw Install the TV bracket locking screw (G) into the TV bracket (A) using the hex key (H). Do not screw in more than three or four turns. Option 2: If the back of the TV is curved or to make room for cables Attach the TV bracket [A] to the back of the TV using the washers (E), the spacers (F), and the screws (D). Note: If the hole pattern on your TV is 75mm x 75mm the washers(E) will not be used. G H Package contents A TV bracket (1) A B B Wall plate (1) M4 bag C M4 x 12 mm screws (4) D M4 x 30 mm screws (4) E M4 washers (4) F M4 spacers (4) M4 bag Miscellaneous bag G Locking screw (1) H 5/32 in. hex key (1) C D M4 x 12mm Miscellaneous bag G Lag bolt bag I 5/16 in. x 2¾ in. lag bolts (2) J Concrete anchors (2) Lag bolt bag I M4 x 30mm H E M4 in. J Tools you will need: • Stud finder • Hammer (Concrete Only) • 3/8 in. masonry • Awl • Tape measure drill bit(Concrete Only) • Level • Power drill • Socket wrench with ½ in. socket • Pencil • 3/16 in. wood drill bit or adjustable wrench • Phillips screwdriver F M4 2 Attach the TV bracket Option 1: If the back of the TV is at Align the TV bracket (A) with the mounting screw holes on the back of the TV. Place the washers (E) over the screw holes on the TV bracket. Note: If the hole pattern on your TV is 75 mm x 75 mm, do not use the washers. Insert the screws (C) though the screw holes and tighten. With washers E C A Without washers A C F A E D With washers F A D Without washers