Ryobi A25RT02 English Manual - Page 16
Attaching The Vacuum Hose, Clamping The Router Table To A Work, Bench, Mounting The Router Table
View all Ryobi A25RT02 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
ASSEMBLY ATTACHING THE VACUUM HOSE See Figure 18. The vacuum port molded into the fence will accept either a 1-1/4 in. or 2-1/2 in. vacuum attachment. CLAMPING THE ROUTER TABLE TO A WORK BENCH See Figures 19. Unplug the router table and/or the router. Place the router table right side up on a sturdy work surface; e.g., leg stand, workbench, counter top. Using a clamp, insert the top front of clamp through the opening in the router table leg. Tighten clamp securely. MOUNTING THE ROUTER TABLE TO A WORK BENCH See Figure 20. Unplug the router table and/or the router. Place the router table right side up on a sturdy work surface; e.g., leg stand, workbench, counter top. Mark the holes with a pencil. Remove the router table. Drill four holes through the work surface. Place the router table back on the work surface, align- ing the holes in the table legs with the holes in the work surface. NOTE: Position the router table surface at approximately hip height. Insert four bolts (not included, 1/4-20 recommended) and tighten securely with flat washers, lock washers, and hex nuts (not included). 1 Inch FEDEIDRECTION VACUUM PORT 3 2 1 0 1 Inch VACUUM HOSE Fig. 18 inch 3 2 1 0 1 Inch WORK TABLE 3 2 1 0 1 Inch CLAMP Fig. 19 BOLTS inch 3 2 1 0 1 Inch FLAT WASHER HEX NUT 16 LOCK WASHER WORK TABLE Fig. 20