Ryobi BGH616 English Manual - Page 12
Mounting Work Rest, Warning, Mounting Grinder To Workbench - 6 bench
View all Ryobi BGH616 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
assembly mounting Work rest See Figure 6. n Remove the knob, star washer, and washer from the car- riage bolt on the lower portion of wheel guard. n Using the slotted screw, star washer, washer and fasten- ing knob, attach the work rest bracket to the inside of the wheel guard as shown. NOTE: The grooved work rest mounts on the left side. NOTE: The work rest bracket's lower slot must be positioned over the pin on the guard. n With the remaining fastening knob, install the work rest to the bracket. NOTE: Adjust the distance between the wheel and the work rest to maintain 1/16 in. or less separation as the diameter of the wheel decreases with use. WARNING: Always make sure your bench grinder is securely mounted to a workbench. Failure to do so could result in an accident resulting in possible serious personal injury. moUNTING GRINDER To Workbench See Figure 7. If grinder is to be used in a permanent location, it should be fastened securely to a firm supporting surface, such as a workbench with bolts. n Use 1/4 in. bolts, washers, and nuts (not included). The bolt length should be 1-1/2 in. plus the thickness of the workbench. n Locate and mark the holes where the grinder is to be mounted. n Drill four 3/8 in. diameter holes through workbench. n Place sander on workbench, aligning holes in base with holes drilled in workbench. n Insert four 1/4 in. diameter bolts and washers and attach nuts securely. wORK REST (RIGHT) Large washer knob WORK REST bracket Fig. 6 CARRIAGE BOLT PIN WORK REST ASEMBLY WASHER knob STAR WASHER Fig. 6 HEX BOLT WASHER WASHERS LOCK WASHER HEX NUT Fig. 7 12