Ryobi CSB125 User Manual - Page 12
To Bevel Cut, Pocket Cutting, Warning, Optional Edge Guide, Optional Dust Nozzle Kit
View all Ryobi CSB125 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
OPERATION TO BEVEL CUT See Figure 20, page 17. Hold the saw firmly with both hands as shown. Rest the front edge of the base on the workpiece. Start the saw and let the blade reach full speed. Guide the saw into the workpiece and make the cut. Release the switch and allow the blade to come to a complete stop. Lift the saw from the workpiece. POCKET CUTTING See Figure 21, page 18. WARNING: Always adjust bevel setting to zero before making a pocket cut. Attempting a pocket cut at any other setting can result in loss of control of the saw possibly causing serious injury. ■ Adjust the bevel setting to zero. Set the blade to the correct blade depth setting. Swing the lower blade guard up using the lower blade guard handle. NOTE: Always raise the lower blade guard with the handle to avoid serious injury. Hold the lower blade guard by the handle while keeping your hand on the front handle, as shown. Rest the front of the base flat against the workpiece with the rear of the handle raised so the blade does not touch the workpiece. Start the saw and let the blade reach full speed. Guide the saw into the workpiece and make the cut. WARNING: Always cut in a forward direction when pocket cutting. Cutting in the reverse direction could cause the saw to climb up on the workpiece and back toward you. Release the switch and allow the blade to come to a complete stop. Lift the saw from the workpiece. Clear corners out with a hand saw or sabre saw. OPTIONAL EDGE GUIDE See Figure 22, page 18. Use the optional edge guide kit, part no. 202218001 when making long or wide rip cuts with the saw. To assemble edge guide: Unplug the saw. Place edge guide through slots in base as shown. Adjust edge guide to the width needed. Tighten edge guide lock knob securely. To use edge guide: Secure the workpiece to prevent movement. Position the face of the edge guide firmly against the edge of workpiece. Guide the saw along the edge to achieve a straight rip cut. NOTE: The guiding edge of the workpiece must be straight for the cut to be straight. Use caution to prevent the blade from binding in the cut. OPTIONAL DUST NOZZLE KIT See Figure 23, page 18. You may purchase a dust nozzle kit, part no. 200673002, for use with the saw. The adaptor fits over the dust chute which is located on the upper blade guard. The nozzle attaches to the adaptor. NOTE: If you use the nozzle, you should always connect it to a standard vacuum hose. To attach dust nozzle: Unplug the saw. Lift lower blade guard. Orient adaptor to fit into the dust chute opening on upper blade guard. Secure adaptor with screw provided. Align hole in nozzle with raised lip on adaptor and snap into place when using a vacuum hose. WARNING: Never tie the lower blade guard in a raised position. Leaving the blade exposed could lead to serious injury. 12 - English