Ryobi CSB135L User Manual - Page 20
To Install The Blade Guard And Anti, Kickback Pawls, Warning
View all Ryobi CSB135L manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
ASSEMBLY TO INSTALL THE BLADE GUARD AND ANTIKICKBACK PAWLS See Figures 14 - 16. WARNING: Replace dull or damaged anti-kickback pawls. Dull or damaged pawls may not stop a kickback increasing the risk of serious personal injury. Anti-kickback pawls should only be installed for through cuts. Unplug the saw. Raise the saw blade by turning the height/bevel adjusting handwheel clockwise. Place riving knife in "up" position. Reinstall the throat plate. To install anti-kickback pawls: Press and hold the button on the right side of the anti- kickback pawls. Align the slot in the pawls over the rear hole in the riving knife. Push the pawl handle down snapping them into place and release the button. NOTE: Pull on the pawl handle to make sure pawls are securely locked. To install blade guard: Lift the guard lever up to unlock. With the front of the blade guard raised, lower the back of the guard into the middle hole of the riving knife. Push the front of the guard down until it is parallel to the table (see figure 16). If the blade guard is not parallel to the table, the riving knife is not in the "up" position. Lock the guard in place by pushing the guard lever down. NOTE: Blade alignment can be adjusted for different blade widths. Refer to: To Check and Align the Riving Knife and Saw Blade. Check the blade guard assembly for clearances and free movement. BLADE GUARD PAWL HANDLE ANTI-KICKBACK PAWLS BUTTON CORRECT GUARD LEVER Fig. 14 Fig. 15 INCORRECT Fig. 16 20