Ryobi OP241A OP241_326_trilingual.pdf - Page 2

Save These Instructions - battery

Page 2 highlights

CHARGE LEVEL INDICATOR ? ? Charge level indicator button PAolCiwmoreerniretanOttieonn TeEvEsavtlauilneuragr CEhnCaacrhrgagarnigndeog CChChaaormrggpelemetdaox. DDeDeeffefeectccuttueiouvsxoe EMnMdeMoo'dédrdoenegdeeedyorng'déeiSeecrgoaaínahvoomerrioe Fig. 1  Charge the battery pack only with the recommended charger.  Connect the charger to a power supply. For a complete list of approved power sources, refer to the operator's manual for the charger.  Press down on the battery pack to be sure contacts on the battery pack engage properly with contacts in the charger.  Make sure the battery pack is secured in the charger before beginning operation.  The battery pack will become slightly warm to the touch while charging. This is normal and does not indicate a problem.  Do not place the charger and battery pack in an area of extreme heat or cold. They will work best at normal room temperature. Note: The charger and battery pack should be placed in a location where the temperature is more than 50°F but less than 100°F.  When batteries become fully charged, unplug the charger from the power supply and remove the battery pack. CHARGING A HOT BATTERY PACK When using a tool continuously, the batteries in the battery pack will become hot. You should let a hot battery pack cool down before attempting to recharge. Note: This situation only occurs when continuous use of a tool causes the batteries to become hot. It does not occur under normal circumstances. Refer to CHARGING THE BATTERY PACK for normal recharging of batteries. If the charger does not charge your battery pack under normal circumstances, return both the battery pack and charger to your nearest Authorized Service Center for electrical check. CHARGING A COOL BATTERY PACK If the battery pack is below normal temperature range it will not charge. Allow the battery pack to warm to a temperature of more than 32°F before attempting to recharge. COLD WEATHER OPERATION The lithium-ion battery pack can be used in temperatures down to -4°F. Put the battery pack on a tool and use the tool in a light duty application. After about a minute, the pack will have warmed up and begin operating normally. BATTERIES These batteries have been designed to provide maximum trouble-free life. However, like all batteries, they will eventually wear out. Do not disassemble battery pack and attempt to replace the batteries. Handling of these batteries, especially when wearing rings and jewelry, could result in a serious burn. To obtain the longest possible battery life, we suggest the following:  Remove the battery pack from the charger once it is fully charged and ready for use. For battery pack storage longer than 30 days:  Store the battery pack where the temperature is below 80°F and away from moisture.  Store battery packs in a 30%-50% charged condition.  Every six months of storage, charge the pack as normal. BATTERY PACK REMOVAL AND PREPARATION FOR RECYCLING To preserve natural resources, please recycle or dispose of batteries p­ roperly. This product contains lithium-ion batteries. Local, state or federal laws may prohibit disposal of lithium-ion batteries in ordinary trash. Consult your local waste authority for information ­regarding available recycling and/or disposal options. WARNING! Upon removal, cover the battery pack's terminals with heavy-duty adhesive tape. Do not attempt to destroy or disassemble battery pack or remove any of its components. Lithium-ion batteries must be recycled or disposed of properly. Also, never touch both terminals with metal objects and/or body parts as short circuit may result. Keep away from children. Failure to comply with these warnings could result in fire and/or serious injury. WARNING: This product contains chemicals, including lead, known to the State of California to cause cancer, birth defects and other reproductive harm. Wash hands after handling. RYOBI is a registered trademark of Ryobi Limited and is used pursuant to a license granted by Ryobi Limited. ONE WORLD TECHNOLOGIES, INC. 1428 Pearman Dairy Road Anderson, SC 29625 Phone 1-800-525-2579 www.ryobitools.com SAVE THESE INSTRUCTIONS

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6

COLD WEATHER OPERATION
The lithium-ion battery pack can be used in temperatures
down to -4°F. Put the battery pack on a tool and use the tool
in a light duty application. After about a minute, the pack will
have warmed up and begin operating normally.
BATTERIES
These batteries have been designed to provide maximum
trouble-free life. However, like all batteries, they will eventually
wear out. Do not disassemble battery pack and attempt to
replace the batteries. Handling of these batteries, especially
when wearing rings and jewelry, could result in a serious burn.
To obtain the longest possible battery life, we suggest
the following:
Remove the battery pack from the charger once it is fully
charged and ready for use.
For battery pack storage longer than 30 days:
Store the battery pack where the temperature is below
80°F and away from moisture.
Store battery packs in a 30%-50% charged condition.
Every six months of storage, charge the pack as normal.
BATTERY PACK REMOVAL AND PREPARATION FOR
RECYCLING
To preserve natural resources, please recycle
or dispose of batteries properly.
This product contains lithium-ion batteries.
Local, state or federal laws may prohibit
disposal of lithium-ion batteries in ordinary
trash.
Consult your local waste authority for
information regarding available recycling and/or disposal
options.
WARNING!
Upon removal, cover the battery pack’s terminals with
heavy-duty adhesive tape. Do not attempt to destroy or
disassemble battery pack or remove any of its compo-
nents. Lithium-ion batteries must be recycled or disposed
of properly. Also, never touch both terminals with metal
objects and/or body parts as short circuit may result.
Keep away from children. Failure to comply with these
warnings could result in fire and/or serious injury.
WARNING:
This product contains chemicals, including lead,
known to the State of California to cause can-
cer, birth defects and other reproductive harm.
Wash hands after handling.
?
Power On
Alimentation
Corriente
Testing
Evaluer
Evaluar
Charging
En charge
Cargando
Charged
Charge max.
Completo
Defective
Defectueux
Defectuoso
Energy Save
Mode
Mode d’économie
d’énergie
Modo de ahorro
de energía
Charge the battery pack only with the recommended
charger.
Connect the charger to a power supply. For a complete list
of approved power sources, refer to the operator’s manual
for the charger.
Press down on the battery pack to be sure contacts on the
battery pack engage properly with contacts in the charger.
Make sure the battery pack is secured in the charger before
beginning operation.
The battery pack will become slightly warm to the touch
while charging. This is normal and does not indicate a
problem.
Do not place the charger and battery pack in an area of
extreme heat or cold. They will work best at normal room
temperature.
NOTE:
The charger and battery pack should be placed in
a location where the temperature is more than 50°F but
less than 100°F.
When batteries become fully charged, unplug the charger
from the power supply and remove the battery pack.
CHARGING A HOT BATTERY PACK
When using a tool continuously, the batteries in the battery
pack will become hot. You should let a hot battery pack cool
down before attempting to recharge.
NOTE:
This situation only occurs when continuous use of a
tool causes the batteries to become hot. It does not occur
under normal circumstances. Refer to
CHARGING THE
BATTERY PACK
for normal recharging of batteries. If the
charger does not charge your battery pack under normal
circumstances, return both the battery pack and charger to
your nearest Authorized Service Center for electrical check.
CHARGING A COOL BATTERY PACK
If the battery pack is below normal temperature range it will
not charge. Allow the battery pack to warm to a temperature
of more than 32°F before attempting to recharge.
SAVE THESE INSTRUCTIONS
ONE WORLD TECHNOLOGIES, INC.
1428 Pearman Dairy Road
Anderson, SC 29625
Phone 1-800-525-2579
www.ryobitools.com
RYOBI is a registered trademark of Ryobi Limited and is used pursuant
to a license granted by Ryobi Limited.
CHARGE LEVEL
INDICATOR
Fig. 1
?
CHARGE
LEVEL
INDICATOR
BUTTON