Ryobi P1111 Operation Manual - Page 15

TROUBLESHOOTING IF THESE SOLUTIONS DO NOT SOLVE THE PROBLEM CONTACT YOUR AUTHORIZED SERVICE DEALER. PROBLEM Handle not in position. POSSIBLE CAUSE Handle locks not locked. SOLUTION Lock upper and lower handle locks. Mower not starting. Mower cutting grass unevenly. Mower not mulching properly. Mower hard to push. Mower not bagging properly. Mower vibrating at higher speed. Motor stops while cutting. Battery is low in charge. Charge the battery. Lawn is rough or cutting height not set Adjust the cutting height. properly. Wet grass clippings sticking to the Wait until the grass dries before mowing. underside of the deck. High grass, rear of mower housing Raise cutting height. and blade dragging in heavy grass, or cutting height too low. Cutting height set too low. Raise cutting height. Blade is unbalanced, excessively or unevenly worn. Replace the blade. Bent motor shaft. Cutting height set too low. Stop the motor, remove start key and battery. Inspect for damage. Have repaired by an authorized service center before restarting. Raise the cutting height. MAKE THE MOST OF YOUR PURCHASE! Your product has been fully tested prior to shipment to ensure your complete satisfaction. For any questions about operating or maintaining your product, call the Ryobi Help Line! This product has a Three-year Limited Warranty for personal, family, or household use (90 days for business or commercial use). For warranty details, visit www.ryobitools.com or call (toll free) 1-800-860-4050. 11 - English