Ryobi P2035 Operation Manual 3 - Page 10

OPERATION If grass becomes wrapped around the string head:  Remove the battery pack.  Remove the grass. WARNING: Always hold the string trimmer away from the body keeping clearance between the body and the string trimmer. Any contact with the string trimmer cutting head while operating can result in serious personal injury. CUTTING TIPS See Figures 10 - 11.  Keep the trimmer tilted toward the area being cut; this is the best cutting area.  The string trimmer cuts when passing the unit from right to left. This will avoid throwing debris at the operator. Avoid cutting in the dangerous area shown in figure 10.  Use the tip of the line to do the cutting; do not force string head into uncut grass.  Wire and picket fences cause extra line wear, even breakage. Stone and brick walls, curbs, and wood may wear line rapidly.  Avoid trees and shrubs. Tree bark, wood moldings, siding, and fence posts can easily be damaged by the line. ADVANCING LINE NOTE: The trimmer is equipped with an auto-feed head. Bumping the head to try to advance the line will damage the trimmer and void the warranty.  With the trimmer running, release the switch trigger.  Wait two seconds, and press the switch trigger. NOTE: The line will extend approximately 1/4 in. with each stop and start of the switch trigger until the line reaches the length of the grass deflector cut-off blade.  Resume trimming. ADVANCING THE LINE MANUALLY See Figure 12.  Remove the battery pack.  Push the black button located on the string head while pulling on line to manually advance the line. LINE CUT-OFF BLADE See Figure 13. This trimmer is equipped with a line cut-off blade on the grass deflector. For best cutting, advance line until it is trimmed to length by the line cut-off blade. Advance line whenever you hear the engine running faster than normal, or when trimming efficiency diminishes. This will maintain best performance and keep line long enough to advance properly. This trimmer is currently set at the 11 in. cutting swath. To adjust to a cutting swath of 13 in.:  Remove the battery pack.  Loosen the blade screw then rotate the line cut-off blade 180°.  Tighten the blade screw. EDGING See Figures 14 - 15.  Remove the battery pack.  Step down on the foot pedal.  Rotate the trimmer head counterclockwise placing the tool in the edger position. WARNING: Always hold the string trimmer away from the body keeping clearance between the body and the string trimmer. Any contact with the string trimmer cutting head while operating can result in serious personal injury. WARNING: Never stand directly in the path of the cutting line while edging. Always stand to the left of the grass deflector to avoid thrown debris, which could result in serious personal injury. 8 - English